Re: What did you do to your truck today.The 3rd chapter
Lookin' good! Now, go put a scuff mark on it before someone else does! :D
|
Re: What did you do to your truck today.The 3rd chapter
2 Attachment(s)
Spent about an hour a night for the past week and a half fixing the two lower corners of my windshield so I can get the glass installed. Took advantage of the opportunity and repainted the top of my dash. Shade is just a bit darker than the fawn interior. Also cleaned up the entire pinch weld area, primed, and painted with a flat black since the glass seal will cover pretty much all of it. Cleaning all the old goop off it went to the metal in a lot of places and I didn't want to leave it that way.
|
Re: What did you do to your truck today.The 3rd chapter
Youngest bro and I (mostly him) made two replacement springs for my truck seat. I'll paint the seat tracks tomorrow, and install them onto the seat bottom and dope out how the release works...or just leave it all the way back. Short stuff wife can't drive it that way though.
|
Re: What did you do to your truck today.The 3rd chapter
Quote:
|
Re: What did you do to your truck today.The 3rd chapter
Quote:
Got the Bumper from Iron Mike. Thanks Russ |
Re: What did you do to your truck today.The 3rd chapter
1 Attachment(s)
Quote:
I'm planning on installing a quick ratio steering gearbox. While I'm at it, I'm going to replace my current one piece decapitator steering shaft with a newer two-piece style with an intermediate shaft. Will improve safety, and will make removing and installing the column easier. I cleaned up and painted an intermediate shaft I bought from Jeff's Bowties. |
Re: What did you do to your truck today.The 3rd chapter
1 Attachment(s)
The only thing I did was install an NV4500 and a 6 bolt round pattern twin stick NP205.
|
Re: What did you do to your truck today.The 3rd chapter
1 Attachment(s)
Quote:
I have a steering box, pump, and bracket from a 73-74 model truck and think swapping to power steering will be a winter project this year. Just gotta figure out which bottom pulley I need for my 283. |
Re: What did you do to your truck today.The 3rd chapter
3 Attachment(s)
Got my windshield washers working and put the cowl back on with the wipers all together. Got my helper with me tonight.
|
Re: What did you do to your truck today.The 3rd chapter
I received a new brake line kit and got it ready to install them on the truck, but noticed something that I need to address. The studs from the brake pedal assembly are getting very corroded, and need replaced. Where can I buy a new brake pedal assembly? All that I can find are just the brake pedal lever, but not the mounting bracket. Thank you for any assistance that you can provide.
|
Re: What did you do to your truck today.The 3rd chapter
Quote:
|
Re: What did you do to your truck today.The 3rd chapter
What did I do with my truck, today? I stood there and looked at it wishing it wasn't so damned hot. Day after day it has been in triple digits with heat indexes over 110. This heatwave is unusual, even for us, this time of year. Some cars shows are being cancelled or, times being moved to earlier AM or later PM.
|
Re: What did you do to your truck today.The 3rd chapter
Quote:
https://www.classicparts.com/1969-74...tinfo/CP-2032/ |
Re: What did you do to your truck today.The 3rd chapter
1 Attachment(s)
New glass!!!! Truck is filthy but the glass is in at least.
|
Re: What did you do to your truck today.The 3rd chapter
Got the seat backrest done. I'm trying to figure out how to compress that foam so that I can pull the cover over it and put in the hog rings on the bottom part. I wonder if they use some sort of squeeze machine in the upholstery shop? I need about 5" of "stretch" to get the cover to the back side attachment wires. My brother says to start at the back. Given that I'm not an upholsterer, I'm tempted to ask for mercy at a local shop.
|
Re: What did you do to your truck today.The 3rd chapter
1 Attachment(s)
New clutch fan . Old one wasn’t doing a damn thing . Truck is running normal temps again at lower speeds . Highway wasn’t a problem as the fan doesn’t do at that much at 70mph
|
Re: What did you do to your truck today.The 3rd chapter
Quote:
|
Re: What did you do to your truck today.The 3rd chapter
2 Attachment(s)
Finally made some time for the 68 Stepper . I think they greased this truck every month . The grease and South Carolina red dirt was caked at least an inch thick on everything . When I started there was no lip on the control arm .
|
Re: What did you do to your truck today.The 3rd chapter
Right on Mark, when I got my old Chevy the valve cover gaskets were leaking so bad it saved things from rusting out, either way it's all good......
|
Re: What did you do to your truck today.The 3rd chapter
3 Attachment(s)
Got the new engine primed and almost ready to fire up.
|
2 Attachment(s)
Dropped it off at the fab shop as a lwb. Hopefully picking it ip as a swb in a couple weeks.
Posted via Mobile Device |
Re: What did you do to your truck today.The 3rd chapter
Quote:
|
Re: What did you do to your truck today.The 3rd chapter
Ordered new wiper blades and a washer bottle/pump for a mid 90's S10 with the intentions of getting the wiper/washers functional when it gets cool enough to work in the shop. Also working on stereo system. Maybe end of September.
|
Re: What did you do to your truck today.The 3rd chapter
4 Attachment(s)
Bought another set of NOS upper trim to get the one I needed for the bed, installed Wednesday. Today I replaced mufflers and tailpipes.
|
Re: What did you do to your truck today.The 3rd chapter
Wow you got your own exhaust pipe bender. Nice!
|
All times are GMT -4. The time now is 01:05 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com