Re: What did you do to your truck today?
Last few days we installed the hood, grille surround, front bumper (i couldn't wait) painted the bed, installed the instrument cluster. pole around here at the last 10 pictures to see what we got done.
painted the bed: http://kieth.smugmug.com/Trucks/66-G...738550_WsMwgkc installed the hood: http://kieth.smugmug.com/Trucks/66-G..._Hn4N37r-XL-LB Installed the Instrument cluster: http://kieth.smugmug.com/Trucks/66-G...6_6RPBQ7f-A-LB Next week we may come close to finishing this puppy up. |
Re: What did you do to your truck today?
Just ordered a new grille from LMC, should have it Wednesday the 29th. Before we put it in we will paint the white accent that surrounds it. I have noticed alot of guys leave that area body color, I think it looks better white, and apparently the factory did too!
|
Re: What did you do to your truck today?
Did you junk that 62 grille???
QUOTE=joedoh;4752356]took out the trash. http://i103.photobucket.com/albums/m...h/IMG_0650.jpg[/QUOTE] |
Re: What did you do to your truck today?
Replaced the lower radiator hose and thermostat. Turns out it wasn't overheating my gage is reading 40 degrees high.
|
Re: What did you do to your truck today?
Pulled out the old trans so i can set in my t5 during the week.
Posted via Mobile Device |
Re: What did you do to your truck today?
|
Re: What did you do to your truck today?
Snuck off to the pull apart in nashville..... they have a lot more truck in....... just not much of any thing I need
|
Re: What did you do to your truck today?
Oil Filter was leaking.
Spun the old one off. Cleaned splattered oil underneath the truck. Spun the new one on. Dang Autozone Plastic Creeper broke and split where the bolts are on the caster. Need a dog bone creeper. It's trash now..... Shook my head. Threw my hands in the air and said, "Serenity Now!" Stuff happens:waah: http://www.gifsoup.com/view7/2640357...ightning-o.gif |
Re: What did you do to your truck today?
Quote:
I did. It was in the classifieds on this site for 4 weeks with less than no interest. |
Re: What did you do to your truck today?
Set the bed on the truck still lots to do but it is starting to look like a pickup.
:gmc2: http://kieth.smugmug.com/Trucks/66-G...7_QhFTT5D-A-LB |
Re: What did you do to your truck today?
Completed ding and dent repairs on the passenger side of the firewall, sprayed the bare metal areas with etch primer, and finished most of the sanding. Also fabricated new gaskets and mounted the heater plates. Pulled the carb and distributor (for open access) as the last task for today. If all goes according to schedule I’ll finish sanding the area behind the engine tomorrow, mask on Thursday and spray on Friday.
http://img862.imageshack.us/img862/4071/post01.jpg |
Re: What did you do to your truck today?
Quote:
|
Re: What did you do to your truck today?
Quote:
http://67-72chevytrucks.com/vboard/s...d.php?t=366853 |
Re: What did you do to your truck today?
Very cool
mb |
Re: What did you do to your truck today?
I broke a bolt off while removing my t-stat housing :-(
|
Re: What did you do to your truck today?
Quote:
|
Re: What did you do to your truck today?
Quote:
|
Re: What did you do to your truck today?
Still scraping old paint off the frame, but finaly got the engine pulled out this morning.
|
Re: What did you do to your truck today?
Finally got the 406 running well, (timing issue) fixed the tranny leak (stupid cheap dipstick), mounted and plumbed power steering pump....took her for a drive and......NO BRAKES....bad way to find this out!
|
Re: What did you do to your truck today?
1 Attachment(s)
Put on the "Custom" sail panel trim pieces from my other truck. I know, they aren't original to this truck, but I really dig the way they look. Plus I had them so might as well use them, right?
Attachment 767767 |
Re: What did you do to your truck today?
Quote:
http://kieth.smugmug.com/Trucks/66-G...598_bmgHN-A-LB |
Re: What did you do to your truck today?
O I had a time.... playing last night
http://i1100.photobucket.com/albums/...p/IMAG0256.jpg http://i1100.photobucket.com/albums/...p/IMAG0257.jpg http://i1100.photobucket.com/albums/...p/IMAG0259.jpg http://i1100.photobucket.com/albums/...p/IMAG0260.jpg http://i1100.photobucket.com/albums/...p/IMAG0262.jpg I just have to lower the front some more and put new socks on the back... |
Re: What did you do to your truck today?
1 Attachment(s)
Cab is back on....and starting to go forward again....
|
Re: What did you do to your truck today?
Quote:
http://www.summitracing.com/parts/TFS-31500811/ I’m not familiar with the vacuum ports on the later manifolds so those connections may require minor attention. |
Re: What did you do to your truck today?
Welded up holes in bed copper pennies are the trick to help when filling holes
Posted via Mobile Device |
All times are GMT -4. The time now is 05:48 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com