Re: What did you do to your truck today?
 

That B Body cluster looks right at home in there! Nice job. The LT1 is going to really haul.

Re: What did you do to your truck today?
 

Thanks for the positive feedback... I have driven it on the road sitting on a bucket, no doors, windshield, fenders, inner fenders, bed, etc. It does run good..

Re: What did you do to your truck today?
 

Had a good day working on the truck despite the fact it was only 32 degrees out. All went well until I broke off a bolt that holds down the thermostat cover...Snap!

Re: What did you do to your truck today?
 

Haha, only 32 degrees, it is minus 32 degrees here, no working outside like you can.:lol:

Re: What did you do to your truck today?
 

Isn't it always frozen in Canada? Ha ha ( I am originally from BC so I can make that comment!) I forgot to add that I have no garage but with no rain it was not too bad!

Re: What did you do to your truck today?
 

Actually did it last week, but installed a class V trailer hitch, Rick's fuel tank with gen 5 Camaro fuel pump module and new poly bushings for my CPP panhard bar all in preparation to tow a mustang home from Ventura

Re: What did you do to your truck today?
 

In the Northern part of Saskatchewan Canada we get a whole 2-3 months of semi warm car weather, whoohoo.:lol:

Re: What did you do to your truck today?
 

Hey if it got too hot your igloo would melt!

Re: What did you do to your truck today?
 

Somedays I wish I was further North where the igloo's are, easy and cheap to build not like all my insulation I put in my house to keep the -20 to -30 plus weather out. Oh well a few more months and the ice will melt and a couple of months of summer, haha.

Re: What did you do to your truck today?
 

I know this weather is horrible. It is almost 80 out there and I would do some work on my truck but I fear I might break a sweat.

Re: What did you do to your truck today?
 

welding up patches in the drivers door. found a good hood for my truck and found a high hump that I want to let go of...

Re: What did you do to your truck today?
 

Figured out I could save the driver side door. Just need to patch the bottom not replace the whole thing.

So, I took measurements, drew an outline of the profile and cut out the rust.

Should finish it up this weekend and start on the passenger side door.

Steven

Re: What did you do to your truck today?
 

We have a heater that works now! Replaced the fan motor which had seized, tore apart the fan switch and cleaned it up with a dremel tool, and ran new wiring. Moved back the radiator and installed the fan shroud, which seems to have solved our overheating issues...very productive couple of days. Still need to order some new heater control levers and knobs but at least everything works now.

Re: What did you do to your truck today?
 

Grandpa was able to repair the original sending unit! We now have a functioning gas gauge. I have two more I will let him take a crack at.

Re: What did you do to your truck today?
 

Pulled the Heater out the other day for a member in need. So today I cleaned up the atifreeze and did a quick polish. Ran into some loose screws but I did tighten the loose bolts on the truck. Checked for leaks where the pipe plugs were installed. Fluids and fuel pressure were good.

Re: What did you do to your truck today?
 

Wiring and trouble shooting some funky lighting issues.. Worked out a crease on the inside of my passenger door.. But dash is working. This pic is with the truck running..

Oh do you think those caprice headlights will look good in the grill.. Kidding..

Re: What did you do to your truck today?
 

Got the headlights and brake lights working and had the windshield installed..

Re: What did you do to your truck today?
 

After over 2 months sitting outside, finally pushed the 'Burb into the shop today, may actually get something done to it.

Re: What did you do to your truck today?
 

Worked on a door and started making a plan to move the battery and placement of the AC dryer and AC hoses..

Re: What did you do to your truck today?
 

Installed hood with hood/cowl seal! Fun fun my wife helped me set the hood!
Heavy and hurry is all she was saying, after she dropped both her bolts! Haha
Making memories! It makes her feel good when she can help, and she is good help!
Posted via Mobile Device

Re: What did you do to your truck today?
 

What a project you're taking on. Looks good. I took my LT1 chevy truck out for another test ride today and will need posi for sure. You'll love how they run.

Re: What did you do to your truck today?
 

Took the truck out for a cruise with the LT1 finally running and can't believe how this thing runs. I've had some warmed over 350's before and this runs so much better. Love the fuel injection. Starts and runs awesome. Here's a pic with engine running and one of me trying out the excelleration. From the pic you can see I need positraction. Picked up a ford 9" rear end with disk brakes, 5x5 lug pattern to match front. Time to install a posi unit and get it under the truck. I had done this same swap with the 9" on a 66 C10 and loved it.

Re: What did you do to your truck today?
 

Installed the drop hitch, ran the wires to the new plug on the truck. Replaced the trans cler lines (old and cracked).

I'm trying to get Clyde ready to pull my 69 Aristocrat Lo Liner.
Posted via Mobile Device

Re: What did you do to your truck today?
 

Got all the body parts on finally, not done yet but she looks done!
http://i1326.photobucket.com/albums/...085D3FE153.jpg
http://i1326.photobucket.com/albums/...0861C7906F.jpg
http://i1326.photobucket.com/albums/...0857321AF2.jpg
Posted via Mobile Device

Re: What did you do to your truck today?
 

Interesting paint job, kind of like it being different. Cool idea.

Re: What did you do to your truck today?
 

Man that looks nice!

Re: What did you do to your truck today?
 

I like it, you know it reminds me of a 56 chevy two tone paint job. If that's a rail cap on your tailgate [don't know if I'm seeing things] where did you get it?
most of the ones I find are for the newer pickups thanx...Vernski:lol:

Re: What did you do to your truck today?
 

It is a Stainless cap, for our trucks and I got it from Borthers! They were the only one that had a fleet side cap!
The paint scheme is airbrushed and it mimics the 56' Nomad! I was really nervous about doing the airbrushing myself but, I really liked how it turned out!
I like it mostly because it is different & I did it myself!
Posted via Mobile Device
http://i1326.photobucket.com/albums/...33F3C29BAF.jpg

Re: What did you do to your truck today?
 

More cutting, welding, and flanging. Out with the rust, in with the patch panels.

http://i6.photobucket.com/albums/y20...psf2a76363.jpg
http://i6.photobucket.com/albums/y20...ps6b149f2d.jpg
http://i6.photobucket.com/albums/y20...psdabb758b.jpg
http://i6.photobucket.com/albums/y20...ps1196d920.jpg

Re: What did you do to your truck today?
 

Finally got the 700r4 crossmember bolted up... Ordered a speedo... Now to get it to the trans shop to finish it...
Posted via Mobile Device

Re: What did you do to your truck today?
 

Finally got the 700r4 crossmember bolted up... Ordered a speedo... Now to get it to the trans shop to finish it...
Posted via Mobile Device

Re: What did you do to your truck today?
 

This part is basically done..

http://img.photobucket.com/albums/v6...n/DSC00336.jpg

And so I started this mess..

http://img.photobucket.com/albums/v6...n/DSC00326.jpg

Re: What did you do to your truck today?
 

I wired my parking lights to come on/stay on with my headlights. It changes the appearence at night, I like the way it looks.

Re: What did you do to your truck today?
 

Yea man I like the way those lights took at night with both on, I got to get around to doing that.

Got her running!!! Took her for a test drive to fill up the tank and then off to a buddies house to figure out the roof issues, ran great! After all that I went over to the parts truck and stripped it of fenders and the wiper cowl and then laughed as my dog got in the engine compartment and couldn’t figure out how to get out! :lol:

Re: What did you do to your truck today?
 

Went to my buddy Harry's house to check the progress on the wood for the bed...

It's planed down rough cut 2" x 10" 100 year old Southern Yellow Pine that was used in the roof system of the old Westinghouse factory buildings in East Pittsburgh, PA.

I bought it off a guy on CL that had been reclaiming and cleaning it to sell... reasonable.

Harry said it was hard on the planer!

He didn't like the nail holes either, but I think they add to the story; besides once it's in varnish they will all be pretty well filled in.

Next Harry's going to make final cuts and groove to GMC Paul's blueprint...

I love the grain and the deep colors.

rg

Re: What did you do to your truck today?
 

Oh man! That lumber is gorgeous!

I wish I had that for my flatbed.

Steven

Re: What did you do to your truck today?
 

Got my new bed floor installed. 1 1/2 inch tonge and groove cedar we pulled off the roof of an old house when I was just a child.
[IMG]http://i784.photobucket.com/albums/y...844430DCE7.jpg[/IMG]

Re: What did you do to your truck today?
 

That looks great Swag! I'm digging the box too...

rg

Re: What did you do to your truck today?
 

Thanks! I built it to hold my tank, compressor and a few tools.

Re: What did you do to your truck today?
 

Put on burb 3rd brake lite on my 66 , works great!

John
Posted via Mobile Device