Re: 67 short step Daily driver build, 5.3 and 33s
 

Got the front clip off yesterday, it went well no broken bolts which I couldn’t hardly believe

https://i.postimg.cc/X7fXRS5g/3-A6-B...-AF32-F9-B.jpg

Got the front suspension and steering all pulled to make way for all the new stuff

https://i.postimg.cc/GhwHgh42/0-B527...2-DE374930.jpg

Got that all done then tore the oil pan back off the motor so that I could drill out the block for the new dip stick, did that then put the pan back on. Pulled the intake to make sure the valley cover wasn’t leaking oil, it wasn’t but it was disgusting under there so took about a hour cleaning and getting it ready for new gaskets

https://i.postimg.cc/6pBTwjLx/1-A405...-D77366-FC.jpg

Re: 67 short step Daily driver build, 5.3 and 33s
 

Got the lower motor mounts done, I’m using the trail blazer rubber mounts and custom brackets on the engine because the factory was to wide to fit where I wanted

https://i.postimg.cc/2V3d0BTD/8-DAC4...-A7-C058-E.jpg

https://i.postimg.cc/nLCTkNwD/54812-...74-C586524.jpg

Re: 67 short step Daily driver build, 5.3 and 33s
 

Engine side mounts, tig welder them up pretty proud of them
https://i.postimg.cc/t4SG7QxZ/B3-B84...3-D08-EFC7.jpg

https://i.postimg.cc/wB18mfXW/B41-EF...20-CDAB0-F.jpg

Little paint
https://i.postimg.cc/xCmwsXFM/5284-F...94-BAAA6-C.jpg

And bolted in

https://i.postimg.cc/fb14jc5M/E48-EB...E7-EBF1-F1.jpg

Re: 67 short step Daily driver build, 5.3 and 33s
 

On to the trans mount, reused the trail blazer mount and modified the factory crossmember to hold it also made it kinda skid like since it hangs down more than I would like
Bottom
https://i.postimg.cc/Hnp6QjGp/B7-A4-...E29-D5-C62.jpg

Top cut out so that the mount can move

https://i.postimg.cc/0jccZxx7/4-EE97...5-C48-FBB6.jpg

In the truck

https://i.postimg.cc/2S3Xcq1y/760715...A1674579-E.jpg

Overall to see how low it hangs, couldn’t do any better trans is just off the floor boards

https://i.postimg.cc/ydCQ8vv3/6-FBB3...-ED93-F297.jpg