Re: Strip to bare metal or not
 

Twice I have not stripped to metal........and twice it bit me in the a$$.

Re: Strip to bare metal or not
 

progress is looking pretty good from here...nice work

Re: Strip to bare metal or not
 

Thank you. The blazer was repainted in 2005/2007 in Utah by whom I have no idea but its a pretty dry state. I going to move forward but do you guys think that the states with higher humidty may have more problems for DIY guys.

Re: Strip to bare metal or not
 

Cars can sit for years in bare metal and not flash rust if kept in a climate controlled environment and people keep their oily fingers off of it. A damp, high humidity garage isn't ideal. I'm in PA and we get pretty high in humidity at times. Cars at a prior shop I worked at had been sitting in bare metal for 5+ years. As long as you give it a fresh scuff/sand prior to epoxy, you'll be good. I would say this mainly applies to mechanically stripped to bare metal. Sandblasted metal will flash rust much quicker and should be epoxied asap. If you sand down to bare metal while fixing dents, don't sweat it and epoxy at your convenience. Providing your garage isn't like 70% humidity 24/7.

Re: Strip to bare metal or not
 

Just out of curiosity, what/who's paint system. Do you plan on using, for final priming/paint ? Single stage or base/clear white ?

Re: Strip to bare metal or not
 

I have not decided on a brand but planning to use acrylic enamel in single stage and in white. what do you guys like to spray enamel or urethane?

Re: Strip to bare metal or not
 

For equipment/tools/general purpose type stuff. I'll use PPG's HBE-400 series (high build epoxy) pimer. And ,AUE-100 (acrylic urethane enamel, uses a catalyst) for top coat. Both used to be pretty affordable. But, I haven't really priced any since before covid. Would be fine for a driver you want to look respectable. And, far better than a rustolium paint job.

Used to spray a fair amount of PPG deltron/dbc and HOK urethane for nice stuff. But, with the last pricing i got for ppg clear. It's mostly HOK now.

Re: Strip to bare metal or not
 

I would spray an acrylic urethane or polyurethane over an enamel if you're wanting single stage. I would simplify it as, enamel is tractor paint tech and urethane is more modern. Base/Clear is always the best for longevity and overall maintenance. An enamel will require more frequent polishing to keep the gloss up over it's life of sun exposure. More polishing will remove overall mil thickness. An acrylic urethane/polyurethane will have better UV protection and hold it's gloss longer. It will eventually loose gloss but it will be a decade+ for something that sits outside and never sees a waxing. Base/Clear is almost a set it and forget it product as far as a lasting finish.

Depending your spray experience. I could argue base/clear is more forgiving to spray then a single stage. As you can clean your basecoat up and then spray clear. And spraying single stage is the equivalent to spraying clearcoat.

Not talking you into anything you don't want. Just spitting some of my .02

White is a hard color to spray. After your first coat. It becomes difficult to see where you are at on the panels. You must sight down the side of the vehicle and watch the product lay as you spray.

I'd be happy to answer questions.

Re: Strip to bare metal or not
 

Starting the take a part so I can finish top of bed rails and inside of tailgate. I drove it out in daylight and I have a few areas (way more than thought) that need a more attention.

Re: Strip to bare metal or not
 

man thats looking good though, nice progress!