Re: LS swappers, post up your pics!!
 

Sounds good! Do you like the Holley efi?

Re: LS swappers, post up your pics!!
 

Been figuring out exhaust and accessory drive fit in a 48.

Re: LS swappers, post up your pics!!
 

My cammed ls6,t56 69 c10http://i803.photobucket.com/albums/y...115_144222.jpg

Re: LS swappers, post up your pics!!
 

Looks like you're going to have some of the same problems I did.
I had to use a swivel thermostat housing for the lower radiator hose to fit, I also should have removed the heater hose barbs and tapped the holes for pipe thread. That way you can put a 90 in. If you don't the hoses will kink and rub against the inner fender.

Also the Sanderson headers would have been a good fit if I didn't have a GTO motor/trans. They fit tight and drop toward the back, leaving more room for your steering linkage. I ended up using Hooker block huggers, they were a pain for fitting the steering.

Re: LS swappers, post up your pics!!
 

Thanks for sharing your experiences. We have several LS based builds going in the 47 - 59 section and are figuring out the variables of what fits, doesn't fit and potential modifications needed.

Dkaufman, man that is a really clean look!

Only pic I have 04 GTO LS1/4L60
Posted via Mobile Device

Re: LS swappers, post up your pics!!
 

Nice! Is the ac compressor down low?

Re: LS swappers, post up your pics!!
 

No A/C I live in Oregon, we usually only have 2 weeks a year over 90 degrees

Re: LS swappers, post up your pics!!
 

My ongoing project. 2015 lt platform 5.3 with the 6l80e. Currently waiting on the ecm to come back from flashing, its proven problematic as there are 2 sets of vats on the new ones...

Re: LS swappers, post up your pics!!
 

Very nice!!!

Re: LS swappers, post up your pics!!
 

Man that's awesome! I've been saying I want the new 14+ truck motors in a C10. Thing should be a monster! Who is cutting down the harness?

Re: LS swappers, post up your pics!!
 

we've done the harness ourselves, not too bad. One big challenge is theres no power steering pump or room for one one these, the silverados use an electric rack and pinion. I solved that with an electric pump.

Re: LS swappers, post up your pics!!
 

pic, sorry its sideways. can't figure out how to flip it

Re: LS swappers, post up your pics!!
 

Here's my recently completed drop member build with cammed 6.0/T56 combo

Re: LS swappers, post up your pics!!
 

Nothing crazy just clean and simple..

Re: LS swappers, post up your pics!!
 

Very nice. Can't wait to see it rolling, :metal:!

Re: LS swappers, post up your pics!!
 

My latest...

Re: LS swappers, post up your pics!!
 

Very clean! Can you tell us about the coil covers? They look like stock rocker covers modified?

Beautiful work!

Re: LS swappers, post up your pics!!
 

Very good look Rob...super clean with touch of factory. Love this truck.

Re: LS swappers, post up your pics!!
 

Thanks!

Re: LS swappers, post up your pics!!
 

Thanks! They are stamped script valve covers that im running adapters on.. The coils at not under them the are relocated under the truck.

Re: LS swappers, post up your pics!!
 

Another LS swap I done a few months back

Re: LS swappers, post up your pics!!
 

Another

Re: LS swappers, post up your pics!!
 

Original Crate Motor:

http://i1178.photobucket.com/albums/...2020.59.28.jpg

Upgrades to Original:

http://i1178.photobucket.com/albums/...2015.04.53.jpg

http://i1178.photobucket.com/albums/...2017.57.29.jpg

Re: LS swappers, post up your pics!!
 

Just in the mock up stage. 2004 5.3 in front of a 2005 CTSV T56. Engine and trans mounts are made, going to final weld them tonight then re-install to confirm fitment. Then the drive train comes back out to clean and paint it along with the frame. Front clip is painted to match the firewall. Still need to make the new fuel tank and plumb the fuel system, get a third pedal installed for the manual, trim down the harness, tune, etc.