Re: What did you do to your truck today?
 

not planning on smoking the wide whites to many times....those things were not cheap you know..

Re: What did you do to your truck today?
 

Good question! Good answer! If you don't know now you know! Lol! The rockers ain't that bad in taking of and replacing I thought it was going to harder. The hard is looking for all the spot welds.:devil:


Posted via Mobile Device

Re: What did you do to your truck today?
 

Good question! Good answer! If you don't know now you know! Lol! The rockers ain't that bad in taking of and replacing I thought it was going to harder. The hard is looking for all the spot welds.:devil:


Posted via Mobile Device
Posted via Mobile Device
Posted via Mobile Device

Re: What did you do to your truck today?
 

Yesterday pulled the rear axle to get ready for cnotch and 2.73 swap...
Posted via Mobile Device

Re: What did you do to your truck today?
 

That new engine is really beautiful.

Re: What did you do to your truck today?
 

I decided to replace all the steel brake lines with stainless so I picked up a double flaring kit to go with my tubing bender. Also got a second angle grinder cause I am really sick of switching out wheels right in the middle of a project.

I finally got the rear end clean enough to paint. That'll get done Saturday morning.

Steven

Re: What did you do to your truck today?
 

Still fighting with new door seals, attempting to re adjust doors
Posted via Mobile Device

Re: What did you do to your truck today?
 

Good day so far, I finished inside my cab today; dash - wooden bezel, wooden clock/radio holder, new knobs, handle for glove compartment (old harley davidson bolt), rubber door lining installed one side, new seat belts installed, A/C vents painted and reinstalled, and GMC door sill plates installed.

Attachment 994355

Attachment 994356

Attachment 994357

Attachment 994358
_________________________________
http://67-72chevytrucks.com/vboard/s...d.php?t=538792

Re: What did you do to your truck today?
 

Painted inside the cowling last night. Looks great! Truck drives better too! :)

Re: What did you do to your truck today?
 

scoured internet and catalogs looking for all of the upgrades I am going to do. Stuck mainly on the type of disc bake conversion. Transplant crossmember and rear to get 5 lug but lose the torsion setup or go with a commercial 6 lug kit up front.........

Re: What did you do to your truck today?
 

Hey guy its bout time you antiup here, thought maybe you sold the truck off...and bought a ricer...:lol:

Re: What did you do to your truck today?
 

made a hood...well kinda

Re: What did you do to your truck today?
 

Today I replaced the guages in the dash, well under the dash.

Before

http://i166.photobucket.com/albums/u...0/IMG_1118.jpg

New guages

http://i166.photobucket.com/albums/u...0/IMG_1122.jpg

After

http://i166.photobucket.com/albums/u...0/IMG_1126.jpg

http://i166.photobucket.com/albums/u...0/IMG_1127.jpg

Just trying to get things to look more uniform.

Re: What did you do to your truck today?
 

Gauge cluster looks good, fits in well with the switchs.

Re: What did you do to your truck today?
 

Thanks!!

Re: What did you do to your truck today?
 

Finished sanding and painting the gas tank.

Attachment 995131

Attachment 995132

Attachment 995133



Then finished sanding the back half of the cab and primered it.

Attachment 995134

Attachment 995135

Re: What did you do to your truck today?
 

Found out the mirror shakes a whole lot less when all three screws are tight!

Re: What did you do to your truck today?
 

Spent the day re-reading everything I can find about actually installing the windshield. Half the success stories install the windshield top first, while the rest start bottom first. I sure wish there was a pictorial posting already in place specific to the 60-63 wrap around windshield. The factory service manual is practically worthless because it offers no installation photos and doesn't address the issue of the glass hitting the roof overhang.

Re: What did you do to your truck today?
 

There is a very good video on this site. Recently done. Major provider. They installed the top first. Someone has a link I am sure
Posted via Mobile Device

Re: What did you do to your truck today?
 

I rebuilt the speedo from junk yard parts, installed a new heater blower motor out of a 77 ford f250 fit perfectly, i had to take the motor out of the ford mount and put it in my stock mount the 62 squirrel cage fit on the shaft fine. put in a new tach.
here are the pictures of my 62 finally have some computer time.

Re: What did you do to your truck today?
 

Attachment 995278

Attachment 995280

Attachment 995279

cut, weld, grind, repeat.

Re: What did you do to your truck today?
 

For my 66 I installed electronic ignition conversion, replaced the turn signal assembly and rebuilt my leaky Carter yf carburetor.

Re: What did you do to your truck today?
 

I finished rewiring the water temp. and oil pressure gauges and stereo. Prewired the Fosgate punch 150 amp and Kenwood EQ. Turned it over for the first time in over 1 year. Gas started shooting out of the front of the carb. Its a Holley 4160 600cfm vacuum secondary, rebuilt it 1 year ago. Also reinstalled epoxied gas tank, new fuel line, hoses, and filters. New sending unit and connecting hose to fuel neck installed. Removed carb. and removed front bowl. Air nozzled and wired out all ports. Checked accell. pump, checked ok. Cleaned out primary nozzles and reinstalled. Turned over and fired right up! Accell good and idle good. Shut-off and looked inside carb. Found secondary venturi is dripping fuel on the right side steadily and fuel is leaking out of the throttle body gasket on the driver's side. UGH!!! More work to do next week!! :smoke:

Re: What did you do to your truck today?
 

Today I replaced the 500 pound, diamond plate step bumper/tow device with an original bumper that I had rechromed. Looks a lot better IMHO.

Re: What did you do to your truck today?
 

Took the week off and got quite a bit done. Still a long way to go... Lots of pics along the way here: http://bikerswag.wordpress.com/category/66-stepside/