![]() |
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
Cleaning
|
Re: What did you do to your truck today? Chapter II
Installed new back up lights that have been sitting on the shelf for years. I rarely drive it at night, so it's not been a big issue. Unfortunately the right side is not working, so I need to investigate.
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
]I didn't post pics from above, so here's one.
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
I kicked this 05 Tundra out of the garage about 2 years ago for my 71 project. Wasn't happy to do that. Our seasons are rough and SW exposure. It wouldn't be the only thing I've sacrificed for the money pit for certain......................The Tundra is truck, so counts. Besides, there's a great cab next to it. ;))
Anyway, I rolled the frame into the single bay, which long story short is no longer used. I used to polish the truck every year no excuses, but go figure, today's the first time I hit it in near two years as well. Happy to see the paint is still good. I swear by Car Pros paint sealant. Been using it 30 years now. Great truck as well. Knock on wood it's only required one repair since new, A/C O-ring $100 installed. |
Re: What did you do to your truck today? Chapter II
3 Attachment(s)
Blend the brakes, installed the front drive shaft
Put the wheels on and put her on the the ground. Now for some decent weather to test the ride. |
Re: What did you do to your truck today? Chapter II
4 Attachment(s)
A little spring cleaning...
|
Re: What did you do to your truck today? Chapter II
4 Attachment(s)
Cut out outer and inner rockers, and fitted the new inners. Weld tomorrow then move onto the outer rockers
|
Re: What did you do to your truck today? Chapter II
2 Attachment(s)
taking my other project to get primered and then hopefully I'll make enough money when done to paint the C10.
|
Re: What did you do to your truck today? Chapter II
I changed the snow tires to summer tires yesterday. Woke up this morning to a snow storm. Last night it was freezing rain. What a country eh. May the sun shine in your world. Have a good one.
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
Cleaned up the chrome. Been about 20 years since its been cleaned.
https://i.imgur.com/TWCb0V6.jpg?1 |
Re: What did you do to your truck today? Chapter II
2 Attachment(s)
Trying to get the new hydraulic master bolted in the factory clutch rod hole and cantilever the push rod in the master.
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
I replaced the clutch disks and plates in my 12-bolt posi today. My spin the wheel test was telling me it was not a posi, so I didn’t know it was until I pulled the cover off. When I did I found several pieces of clutch disk sitting on the bottom.
Fortunately it didn’t trash something else, and all I had to do was replace the disks and plates. The axle is out of the truck, which made it much easier. |
Re: What did you do to your truck today? Chapter II
4 Attachment(s)
I gave my girl a CLR bath. Some before and afters:
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
2 Attachment(s)
And also got my bumper repainted to get rid of the black stripe on top. Well I had my dad do it because he has 20 years experience with body work and paint. Did some black fade to give it some character and then flat cleared it. Before and after:
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
The boy wirewheeled his frame. Got some paint on it and set motor and tranny in. He’s getting ancy since it’s been July when he wrecked.
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
3 Attachment(s)
I finished the topside welds on the rocker installs and flipped her over to get to the bottom easier, because I hate molten balls of steel burrowing in my flesh. That would be a good thread name ...”molten balls of steel”. Also , I closed up the factory gashole. Someone needs to clean the garage.
|
Re: What did you do to your truck today? Chapter II
Quote:
Looks awesome. Some boiled linseed oil next? |
Re: What did you do to your truck today? Chapter II
2 Attachment(s)
Quote:
Quote:
Here’s a shot of the other side of the bed and cowl. I’ll try to get a decent picture of the whole truck in a few days when it stops raining, still haven’t got to drive her for over 4 months now because of the weather :( |
All times are GMT -4. The time now is 04:57 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com