Re: 5.3 into 72
 

Took the truck out on its first drive today. All seems fine except the trains starts out in 3rd gear and not first. I still have to troubleshoot this as its a bit of a headache

Re: 5.3 into 72
 

I ended up mailing BP my ECM and TCM today. I tried to pull codes with a scan tool today and the scanner powers up but wouldn't link. Bill said the TCM is the first link up for the scan tool and he seems to think the place that sold me the setup may have just sent a non matching TCM. I hope this is the case. I had constant and switched power at the TCM connector.

Re: 5.3 into 72
 

Any updates yet?

Re: 5.3 into 72
 

What fuse/ relay center did you use.? On my 2005 5.3 , I used under hood fuse box for connecting stock harness. Unfortunately the tranny got its power from the interior fuse center on that model truck. Found out the hard way it wouldn't shift. Did some digging to find that out. God luck. Jim

Re: 5.3 into 72
 

No updates yet and bp automotive built my harness and fuse box.

Re: 5.3 into 72
 

Have a small update. I may have my issue figured out. There was a communication wire from the ECM into the TCM that wasn't making contact to the TCM. Just waiting to get it all hooked back up to test it. Then it's just a matter of having my exhaust system built and she should be road worthy. I have plans to take her to the rod run in gatlinburg tn this September.

Re: 5.3 into 72
 

Well, the communication wire was the issue. I got it all back together tonight and the trans has 1st gear now.

Re: 5.3 into 72
 

What issue did you have with the communication wire , was it with the connectors or ?

Re: 5.3 into 72
 

The connector on the tcm wasn't making contact. The connector backed out of the harness just enough so there was no contact.

On another note I just set up an appointment for my exhaust to be run. I'm going with 2 1/2" with an X pipe, spin tech mufflers and turn downs right at the rear bumper.

Re: 5.3 into 72
 

I have a 6.0 in my 72. I built it to drive it. With that in mind, I'm on my 3rd set of mufflers. I found the Dynomax VT mufflers to have the period correct sound with no drown at highway speeds. Turbo mufflers and Flowmaster 40s were great as long as I kept it under 60. The flow's sounded great, but made my ears bleed at hwy speeds.
I'm using the 2 1/2" kit exhaust from Summit. Tail pipes angles behind the wheels.
Good Luck,
Jaime

Re: 5.3 into 72
 

I was going to use flowmaster 40's, but I decided I wanted something a little different. I went with spin tech as I like chambered mufflers.

Re: 5.3 into 72
 

Well, I have most things tightened up now and the truck is at the shop for exhaust. I had a p0300 code last night and after some troubleshooting found out I had two bad injectors. Once I pick the truck up I'm gonna run some fuel system cleaner through it just to make sure my other injectors are up to par. It will be nice to finally be able to drive her again.

Re: 5.3 into 72
 

Had the exhaust ran today. They said they couldn't get an X pipe in so they ran an H pipe. They did a great job and the new power train seems to be running very well so far.

http://i1126.photobucket.com/albums/...A7170101_1.jpg

http://i1126.photobucket.com/albums/...F5043A4BC9.jpg

http://i1126.photobucket.com/albums/...0BB43CB613.jpg

Re: 5.3 into 72
 

How do the SpinTEch mufflers sound and which ones did you choose.?

Re: 5.3 into 72
 

I like the sound of the spin techs. I ordered them from Maryland speed and they didn't give a series, just a 9x12 measurement. They are tame at idle, but wake up at full throttle. I am happy with them.

Re: 5.3 into 72
 

trucks looking nice...planning on doing a swap soon...iam also here in bragg and was wondering is there many swap around here i would like to find some one to give me advice when i start

Re: 5.3 into 72
 

I've seen a couple of 67-72s on post, but I haven't met them and don't know if they have LS's.

Re: 5.3 into 72
 

Do you drive the truck to post alot ? I would like to check it out and be able to know some one that already done a swap...from what seem it looks pretty straight forward and i know there are still hidden challenges

Re: 5.3 into 72
 

Well I've made a few changes to the truck as I've been driving it. Working the bugs out. I'm making the trip to pigeon forge in September for the shades of the past Rod run. It's been nice to have the truck back on the road. I've cleaned up and painted the master cylinder since these pictures lol

http://i1126.photobucket.com/albums/...854EC1F6DD.jpg

http://i1126.photobucket.com/albums/...2E31509764.jpg

Re: 5.3 into 72
 

Looks very good. Hopefully not too many bugs to fix.

Re: 5.3 into 72
 

There were a couple small coolant leaks and the first trans cooler I had on wasn't up to par. That stuff seems to be worked out now though.

Re: 5.3 into 72
 

Any pics of the h-pipe set up??

Re: 5.3 into 72
 

Looks great!

Re: 5.3 into 72
 

The next time I have it up in the air I'll take some pictures of it.

Re: 5.3 into 72
 

I've never attempted to post a video. So here's my first attempt at it. A quick exhaust sound clip

http://s1126.photobucket.com/user/je...7F4C1.mp4.html