Re: What did you do to your truck today?
Quote:
I put Stovebolt double barrels on my girl today.... http://i255.photobucket.com/albums/h...70chevy037.jpg http://i255.photobucket.com/albums/h...70chevy038.jpg http://i255.photobucket.com/albums/h...70chevy036.jpg http://i255.photobucket.com/albums/h...70chevy039.jpg |
Re: What did you do to your truck today?
Quote:
Pat |
Re: What did you do to your truck today?
Quote:
|
Re: What did you do to your truck today?
I got the 66 fired up today. Was nice to hear is rumble through the open headers. :metal: Now I just have to get the tranny all buttoned up. I did take a short video of it but have to upload it. Now I just have to figure out how.. :lol:
|
Re: What did you do to your truck today?
worked on a tune up of the 63... the distributor has had ductape on it since I got it... it ran ok and I had other things going...I looked into it today, and the tape was holding the cap on:lol:one screw missing, and on the other side a wood screw-haha, you gotta love farm trucks!
so the rotor was tearing the sh*t out of the cap since itwas just loose on there! new cap rotor, and wires made it run tons better, tomorrow I chase that pesky acellerator pump, and time it, and it might run like new! |
Re: What did you do to your truck today?
Quote:
http://www.por15.com/ malibob, im digin that seat. did you recover it? |
Re: What did you do to your truck today?
2 Attachment(s)
Found low oil pressure after engine warm up.... pulled the motor only to find out more bad news. Cam bearings shot, main bearings shot, # 7 piston wall no bueno. :censored:
|
Re: What did you do to your truck today?
Quote:
http://www.windshieldstogo.com/ They have warehouses throughout the US that you can pick the glass up and save shipping. |
Re: What did you do to your truck today?
thanks
|
Re: What did you do to your truck today?
Replaced the ignition switch and the starter solenoid trying to sort out my starting problems only to discover the wire plug next to the heater box was unplugged the whole time! :banghead:
I thought about taking both parts back but I didn't feel like uninstalling them plus they were cheap and they'll probably last another 43 years anyway. |
Re: What did you do to your truck today?
finished the floor shifter install. much better now!!
|
Re: What did you do to your truck today?
4 Attachment(s)
picked up my grill and trim from the powder coater this morning, then sandblasted my headlight backing plates, headlight mounts and rear license plate bracket. gonna paint them this afternoon then assemble them.
|
Re: What did you do to your truck today?
Willy P is the grill powder chrome or silver? Thanks, Tony
|
Re: What did you do to your truck today?
2 Attachment(s)
the color is bengal silver with a coat of clear. the "chrome" looked like tin foil to me. a couple better pics..
|
Re: What did you do to your truck today?
Quote:
|
Re: What did you do to your truck today?
1 Attachment(s)
heres a pic of a annodized grill and it does have a tin look to it thats why I asked thinkin about doin my grill powder chrome
|
Re: What did you do to your truck today?
I have been chasing fuel guage issues today...
here is a thread I started in electrical, if you have any suggestions it would help! http://67-72chevytrucks.com/vboard/s...d.php?t=408758 |
Re: What did you do to your truck today?
Ordered a Edelbrock Carburetor Rebuild Kit yesterday for my Edelbrock Carburetor.
Once we get the carburetor rebuilt I will take a video of the exhaust sound of the HOME MADE EXHAUST! http://www.jegs.com/images/photos/300/350/350-18064.jpg http://www.jegs.com/i/Edelbrock/350/1477/10002/-1 http://67-72chevytrucks.com/vboard/s...44#post4044344 |
Re: What did you do to your truck today?
Quote:
I have been thinking the same thing. http://67-72chevytrucks.com/vboard/a...1&d=1276708760 My Original Painted grill is in near perfect condition! (Rare) http://67-72chevytrucks.com/vboard/a...1&d=1276707633 Advanced Plating 1425 Cowan Court Nashville, TN 37207 http://www.advancedplating.com/resto...rill_resto.htm Tri-City Plating Co., Inc. 218 E. Mill St. Elizabethton, Tennessee 37643 http://www.tricityplating.com/ |
Re: What did you do to your truck today?
62, that grill looks good still. sweet rig too!
|
Re: What did you do to your truck today?
Quote:
|
Re: What did you do to your truck today?
Quote:
|
Re: What did you do to your truck today?
Quote:
Building her Carolina Style!!!!!!! Wish I a little bit more money to put in her!!!! I would make her fish tail!!!!!! http://public.bay.livefilestore.com/...res.gif?psid=1 |
Re: What did you do to your truck today?
Spent some time getting the frame stripped clean of years of grime and oil leaks. Used engine brite, super clean, wire brush, putty knife and finished it with a wire brush wheel on my 4 1/2" grinder. I'm going to wipe it down with acetone and prime and paint it today.
http://i148.photobucket.com/albums/s...963C100011.jpg http://i148.photobucket.com/albums/s...963C100013.jpg |
Re: What did you do to your truck today?
Thanks to Bob at Accessoryland, a pair of new old stock inside spotlight brackets (8205 & 8206RH) arrived today. In addition to the mint condition brackets, even the 1960 era slot head mounting screws were included. After decades in wax paper bags, the brackets are now permanent features in my cab.
|
Re: What did you do to your truck today?
Quote:
|
Re: What did you do to your truck today?
started it and saw how quick and high i could rev it
it gets to 7 grand pretty fast :D |
Re: What did you do to your truck today?
2 Attachment(s)
Quote:
|
Re: What did you do to your truck today?
your gonna blow that motor Gage.
Well it was sad what I did to my truck today. I pulled all of my SD front crossmember and my disc brake set up off, so I could sell it. Packed up the air ride kit too. It's all going to a good home though. |
Re: What did you do to your truck today?
well that sucks your selling it
|
Re: What did you do to your truck today?
1 Attachment(s)
Didn't do anything to my truck today, but got started on my shop and I'm excited about that. Will be nice to stay warm this winter....Vernski:two:Attachment 599139
|
Re: What did you do to your truck today?
Started the rebuild and drop process on my 65 frontend today. I removed everything except the tie rods and center link,ran out of time. Now comes the clean up and rebuild part. I'm trying to decide what kind of control arm bushings to use, stock, urethane, poly or polygraphite.....
|
Re: What did you do to your truck today?
4 Attachment(s)
Pics added including side view of rear end with it's new altitude or lack of....
|
Re: What did you do to your truck today?
installed some headers on my dads 67
putting exhaust on it tomorrow super 40 flowmasters |
Re: What did you do to your truck today?
got my drop spindles from summit. ordered them wednesday got them on thursday.:bann::D very happy.
couple hours at it and finito!!! http://i848.photobucket.com/albums/a...project308.jpg 4-1/2 front & 4 in back http://i848.photobucket.com/albums/a...project320.jpg |
Re: What did you do to your truck today?
(((( 1Bad62Pro/Street )))) One Bad Mamma Jamma Project: "Full Metal Yellow Jacket" Breathing life back in my Ole' 62 after it has sat for 4 Years...... Have not rebuit the carb yet!!! Still out of tune! 1962 CHEVY C10 1/2 TON STEPSIDE NOSTALGIA PRO/STREET PROJECT: "FULL METAL YELLOW JACKET" UNDER CONSTRUCTION http://67-72chevytrucks.com/vboard/s...d.php?t=321173 http://2tb6gq.bay.livefilestore.com/...mma.jpg?psid=1 |
Re: What did you do to your truck today?
Sweet, sounds good. Back in the saddle again :metal:
|
Re: What did you do to your truck today?
Got my entire cab blasted today from to to bottom inside out and under:lol:
|
Re: What did you do to your truck today?
5 Attachment(s)
Lets see, I finished half of my 2 1/2" polished stainless exhaust and mounted my cab. Let me know what you think.
|
Re: What did you do to your truck today?
Looks awesome!!! :metal::metal:
|
All times are GMT -4. The time now is 09:44 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com