Re: LS factory cruise control hook up
Quote:
http://i284.photobucket.com/albums/l...t/P9140073.jpg http://i284.photobucket.com/albums/l...t/P9140074.jpg http://i284.photobucket.com/albums/l...t/P9140075.jpg http://i284.photobucket.com/albums/l...t/P9140076.jpg http://i284.photobucket.com/albums/l..._Relays_DD.jpg There may be more info in my build.. |
Re: LS factory cruise control hook up
Hey nova you have a pm
Posted via Mobile Device |
Re: LS factory cruise control hook up
Quote:
|
Re: LS factory cruise control hook up
Quote:
Any type of relay would work.. you would not have to use the micro ones I used. You could use regular Bosch type relays... |
Re: LS factory cruise control hook up
Quote:
|
Re: LS factory cruise control hook up
Crash, clean out your PM box.....:D.
|
Re: LS factory cruise control hook up
Quote:
|
Re: LS factory cruise control hook up
What does it take to get cruise working on a GenIV?
|
Re: LS factory cruise control hook up
Scribed to this one too
|
Re: LS factory cruise control hook up
Hooked mine up on my 72 GMC with 01 6.0 dbc but its not working. I have led taillights. What do I need to check ?
Posted via Mobile Device |
Re: LS factory cruise control hook up
Quote:
Posted via Mobile Device |
Re: LS factory cruise control hook up
I have power at pink and purple. Am I supposed to have any power at vss out or K on module?
Posted via Mobile Device |
Re: LS factory cruise control hook up
Hooked a 2k resistor in there and now it works. Thx.
Posted via Mobile Device |
Re: LS factory cruise control hook up
I just swapped in a 6.0 in a 86 k10 with a 700r4 Mabee I missed something but can this work with a 700 r4 with a psi harness? I have the cruse box that would mount on the firewall of a 99-02 truck. My swap is also drive by cable.
Posted via Mobile Device |
Re: LS factory cruise control hook up
Quote:
|
Re: LS factory cruise control hook up
Well it's an 86 so it has a cable speedo. So I'm assuming unless I get some aftermarket converter to get a vss output it's a no go?
Posted via Mobile Device |
Re: LS factory cruise control hook up
Speartech labeled a yellow wire for my speedo output. I spliced into that on mine.
Posted via Mobile Device |
Re: LS factory cruise control hook up
Quote:
|
Re: LS factory cruise control hook up
Quote:
Quote:
http://www.dakotadigital.com/index.c...rod/prd109.htm |
Re: LS factory cruise control hook up
Quote:
|
Re: LS factory cruise control hook up
Back over on page 2 of this thread "farmtruck" asked about dbw, cruise, and the ebrake. I believe I am running into this same issue. I have a 2005 DBW out of a Tahoe and have wired, checked, re-checked, and checked again all of the cruise, brake switch, and TCC switch connections... all are good but still no cruise.
How do I get the cruise to work? I have a total of three harness connections. 1. The main harness to the computer 2. Two harnesses on the TAC black box. I have spent hours looking for possible solutions with no results. Any help is appreciated. Thanks. |
Re: LS factory cruise control hook up
Quote:
|
Re: LS factory cruise control hook up
Quote:
4 wires from the tac for the cruise: gry/blck, blue, gry, light blue. Light blue to brakes "on" switch (again used a relay here for the blue brake and TCC purple). Brake lights are standard and I have adjusted the brake switch so they come on when the pedal is pressed. Should I check to see if there is a voltage leak out of the switch? It is the original. Thanks for the questions your name comes up in a ton of forums regarding cruise and LS swaps, nice to know I am in good hands. Mark |
Re: LS factory cruise control hook up
PROBLEM SOLVED! After replying in the message above I went out to dinner. This has been driving me nuts and I am sitting there eating when it hits me... I had wired the light blue brake "on" wire into the relay opposite the TCC. Technically correct, it will get 12 volts when the pedal is pressed, it also creates the same problem found when folks install leds with no resistors = no resistance on the line.
Got home, grabbed the flashlight and attached the light blue wire direct to the brake lights "on" side of the brake switch. Woohoo we have cruise. See you are a miracle worker. :) |
Re: LS factory cruise control hook up
Cool, glad you got it figured out. Saves me a lot of typing on my phone. Lol
|
All times are GMT -4. The time now is 04:22 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com