Re: What did you do with your truck today, Part 3
1 Attachment(s)
Finished the battery mount. Side post to the rear. Cables run down the back and down the firewall.
|
Re: What did you do with your truck today, Part 3
Quote:
Brian |
Re: What did you do with your truck today, Part 3
Quote:
|
Re: What did you do with your truck today, Part 3
Quote:
Brian |
Re: What did you do with your truck today, Part 3
Quote:
|
Re: What did you do with your truck today, Part 3
drove the death rattle all day. I fall more in love every time I drive it. I didn't get any work on the truck done. I did clean out the garage which will lead to better work later on. well I guess I did a tiny bit of work if you count prep/research. I took the new a/c bracket out and held it in place and went over the directions while looking at the motor. I already knew I was going to have to move the fuel line over a couple of inches but I will also have to cut the alternator bracket spacer to allow the a/c compressor bracket AND the alternator bracket occupy the same mounting hole the on the head. that means im going to have to get a bolt that matches all of the a/c compressor bracket bolts for the alternator. I believe I found a winner though. its supposed to rain all week here so maybe I will get some work done during the week.
|
Re: What did you do with your truck today, Part 3
I went to an antique swap meet and even though it was a non-automotive event I miraculously found a set of inside door and window handles for my AD, and a pair of tail lights.
|
Re: What did you do with your truck today, Part 3
Quote:
Brian |
Re: What did you do with your truck today, Part 3
1 Attachment(s)
Tested all my gauges for proper operation, installed a rheostat behind the dash for final brightness configurations.
|
Re: What did you do with your truck today, Part 3
okay.. I got out to start on my compressor bracket. I didn't get as far as wanted. mistakes were made along with messes. I had to lay my alternator to the side. easy. then I started following the installation instructions. the first step is to grind a small area. did it. install the cradle on the top water pump bolt. done. remove 1st manifold bolt. done. here is where it gets messy. I needed to remove the heater hoses from the manifold and water pump just to have some room to move. coolant everywhere. its a disaster in my garage. got that handled. the bracket sits just about right but I have some more work to do. I need to make 2 spacers and make sure my belt lines up. the good news is that the bracket will work on top of my alternator bracket. im stoked about that.
|
Re: What did you do with your truck today, Part 3
3 Attachment(s)
I was BEAT today at work, fell asleep in the lunch room! And I love my five minute a day plan, that's all I was going to do, clamp the seat riser in to place, that was it. Well, I got it all welded and ground and the front brackets welded in, it's done!
I then went out for a 2+ mile walk! :metal: Brian |
Re: What did you do with your truck today, Part 3
Raised my truck on jackstands and had my wife step on the brake pedal while I spun the wheels. My brakes are now fully functional!
Between the faulty proportioning valve, adapting GM hoses to Ford calipers, and the inevitable leaks, what an ordeal these brakes have been! |
Re: What did you do with your truck today, Part 3
1 Attachment(s)
First drive after the new paint.
|
Re: What did you do with your truck today, Part 3
Quote:
|
Re: What did you do with your truck today, Part 3
So cool! :metal:
I remember reading an article in the old "Rod Action" magazine back in the seventies about taking that first drive and how all the busted knuckles are forgotten. I wish I had a copy of it, it was really well done. Brian |
Re: What did you do with your truck today, Part 3
Quote:
|
Re: What did you do with your truck today, Part 3
Quote:
Also my first ride in this truck was as a newborn, my parents brought me home from the hospital in it back in '78. It did feel pretty good taking it out on Father's day. |
Re: What did you do with your truck today, Part 3
Quote:
I'll have my truck and camper there. |
Re: What did you do with your truck today, Part 3
Quote:
Brian |
Re: What did you do with your truck today, Part 3
jweb, cool truck and great story...Jim
|
Re: What did you do with your truck today, Part 3
I had a meeting for work 50 miles away that was 3 hours of mind numbing crap, got home after 10 pm and got out to the garage for my five minutes! I punched and drilled holes in the cab and in the panels I am welding in at the cowl at the bottom of the hinge pillars. WHOOO HOOOO!
Brian |
Re: What did you do with your truck today, Part 3
Looking very nice, great color and story.
|
Re: What did you do with your truck today, Part 3
1 Attachment(s)
Started my wiring tonight, guess this counts as my 5 minutes.
|
Re: What did you do with your truck today, Part 3
My 5 minutes was to go pay for the PPG paint, over $1000/with tax for a gallon of paint and nothing else....:tim: and I need 1 1/2 gallons minimum!
|
Re: What did you do with your truck today, Part 3
Quote:
|
All times are GMT -4. The time now is 02:30 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com