![]() |
Re: What did you do to your truck today!
Quote:
Quote:
|
Re: What did you do to your truck today!
Centered my steering wheel. It was off by a quarter turn. Then I replaced my left turn signal canceling spring. I was the guy whose left turn signal never gets turn off.
|
Re: What did you do to your truck today!
drove it...for the first time in about eight years I took it for a drive!!! also did a little body work and started smoothing my top!
|
Re: What did you do to your truck today!
I removed my saginaw 4 speed and tried in install a T5. I ran into a small problem with the clutch disk, I had bought an 11 and actually need a 10 inch clutch disk. I will start over next Saturday!
|
Re: What did you do to your truck today!
put the motor, trans, and tcase in my 4x4 :chevy:
|
Re: What did you do to your truck today!
4 Attachment(s)
Finished installing front drop springs, spindles, shocks, ball joints, tie rods, etc.
|
Re: What did you do to your truck today!
2 Attachment(s)
I pulled the seats out,, again, and put in the speaker and storage box I made and then put the seat back in,,, i probably should have wiped it down before I took the pics,:dohh:
Attachment 682750 Attachment 682751 |
Re: What did you do to your truck today!
Quote:
|
Re: What did you do to your truck today!
got a new alternator today =) I really wanted a chrome one, but that will have to wait.
|
Re: What did you do to your truck today!
Quote:
|
Re: What did you do to your truck today!
Polished some chrome and did a compression test on the engine. All came out at 149 almost exactly. But I am still blowing a little smoke out the passenger side pipe when I romp on it.
|
Re: What did you do to your truck today!
Quote:
|
Re: What did you do to your truck today!
Put in headlight relays. I can't wait til it's dark to see the fruit of my labor!
|
Re: What did you do to your truck today!
4 Attachment(s)
I got the itch to work on the truck today so I braved the cold and bolted down my new bed mounted tool box... I also did some repair to my heater switch plug... Next up on the to-do list is to install my Skip White HEI... :metal:
|
Re: What did you do to your truck today!
2 Attachment(s)
did a little more work on the replacement dash, wire wheeled the paint off, and cut out the radio hole. i offset the hole to the right because i am going to add a push button starter on the left side of it. i also might add a few other things as well but not sure yet, and i would have to figure out what exactly that would be first lol.
Attachment 683594 Attachment 683595 |
Re: What did you do to your truck today!
4 Attachment(s)
not much of an update as of yet, but, just some messing around. took a pic of the current engine setup as i dont have a pic of that in here. i also pulled the springs out of the front to see how low it is. still need to finish the lower arms, and install bags and spindles, but i only have 3/4" before the arms hit the grond:devil::metal:
Attachment 683925 Attachment 683926 Attachment 683927 Attachment 683928 |
Re: What did you do to your truck today!
I bumped into it with my 2002 Silverado while pulling into the driveway.
|
Re: What did you do to your truck today!
have not touched it in a year.
|
Re: What did you do to your truck today!
ouch! did it do any damage???
|
Re: What did you do to your truck today!
Replaced inner and outer tie rod ends, upper and lower ball joints, and cut one coil out of the front springs. Tried my wipers and found that I had installed the linkage backwards. Had to take the cowl off and swap the pivot arm. Buttoned her back up and parked her in the garage. I had replaced my rear springs with Jeep TJ springs awhile back. I finally got around to measuring the drop and come to find out one side is 1.75 inches higher than the other. I guess I will fork out the 100 bucks for real drop springs. I should have known better but it sounded like a great deal(the TJ springs).
|
Re: What did you do to your truck today!
No, not that I can tell. I really don't know how it didn't mess something up. It does have 4 inches of snow on it so who knows.
|
Re: What did you do to your truck today!
Quote:
|
Re: What did you do to your truck today!
Pulled engine/trans (mock-up) Prepped for powder coating. Cut 4" exhaust holes in frame. Sandblasted A-arms.
http://i806.photobucket.com/albums/y...mas2010093.jpg http://i806.photobucket.com/albums/y...mas2010099.jpg http://i806.photobucket.com/albums/y...mas2010096.jpg |
Re: What did you do to your truck today!
I put the first coat of teak oil/thinner on the red oak bedwood,just the start of many coats.
|
Re: What did you do to your truck today!
Quote:
|
All times are GMT -4. The time now is 02:54 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com