![]() |
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
Got myself a cup holder!
|
Re: What did you do to your truck today? Chapter II
Quote:
DAMN:jdp: |
Re: What did you do to your truck today? Chapter II
3 Attachment(s)
Bought a set of black plates for RAT's '71 front clip and roll pan.
|
Re: What did you do to your truck today? Chapter II
Tranny pan trouble. Tranny pan was leaking. Bought a gasket with filter. Jack up the truck, drain the pan, removed the 11 bolts & the trouble began. The two rear bolts I could not get to. I had two V two slots on the side of the tranny mount. Then the pan would not come on the rear. I had to jack up the rear of the tranny to release the pan, Tranny bolts had to be remove to do this. I have a 71 GMC> Why do I have this problem ? Anyone else run into this. I wonder if my Rear tranny mount is collapsing.
|
Re: What did you do to your truck today? Chapter II
5 Attachment(s)
got the da out and had at the underhood a little bit got the passenger side good inner fender ,took out the battery box and did the inner rad support and the little cover for the fan . took a little primer and spray can semi gloss black to it don't know if you can see in pics but huge difference in person . I also got rid of the ugly stickers someone put on the doors and lastly I picked up a set of 15x8 rally wheels no centers or trim rings but got em real cheap
|
Re: What did you do to your truck today? Chapter II
over the weekend i got my tail,back up,and front turn sig/drive and plate lights finished up.
today it was sand,sand,sand.rear bumper & headlite bezels.(searched my stash for hours too find the 8 correct screws for these headlite bezels):lol: I wanna get all the white(526)sprayed this weekend.(i still need too blast & prime my ringed/painted gas cap too do so)busy busy busy.... but on the other hand i went too pull the truck out the other weekend and my choke cable broke...wtf. the coated/spiral sheathing broke off the solid tube that screws too the dash/bezel.it must've been flexed too much at some point.I thought about trying too weld it together. but that could be tough. what a pita. if its not one thing its another. been lookin on the parts b with no luck.the cables at the auto stores dont have the threads too be able too screw a oe chrome bezel nut on too. gotta have that.;) |
Re: What did you do to your truck today? Chapter II
All I did yesterday was spray Rust Treatment from NAPA onto the hood latch. I had finally derusted it to my minimal liking.
|
Re: What did you do to your truck today? Chapter II
3 Attachment(s)
Finally finished! almost, I still have to get the other two carbs fuel line made up, I just wanted to get the bugs out with just one carb, I took it for a 5 mile drive to see how things were. Temp stayed below 190, oil pressure was fine, I have to drive it more to get the rings seated. I'm cleaning up the underside of the hood before I put it on. I'm a happy guy!
|
348 tri-power :c2:
|
Re: What did you do to your truck today? Chapter II
That's sick!
|
Re: What did you do to your truck today? Chapter II
Quote:
You won't regret it if you have those wheels blasted and powder coated in the color of your choice.. |
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
2 Attachment(s)
Attachment 1423866
Attachment 1423867 I feel out of place you'all are working on your trucks! WAY cool "W" Tri power Hamjet! I'm just throwin' the scrap on for a run to the scrap yard tomorrow. It actually quit raining here for now!! |
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
Since you're working, Redline:
Loaded up two old laser printers, a parts bicycle and about ten big cardboard boxes (all broken down). Fit 'em all under the tonneau. Headed to recycle the first of the week. Needed to make some room in the garage and the truck bed for RAT's new "spare tire". |
Re: What did you do to your truck today? Chapter II
Bought truck last Friday. Had bad oil leak. Discovered valve cover bolts weren't even finger tight. Bought the rubber gaskets with the metal frame and new bolts, then torqued to 60 inch pounds as called for in gasket instructions. Leak gone!
|
Re: What did you do to your truck today? Chapter II
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
I put all my carpet, seats and console in. Put doors on and started putting moulding on.. I'm currently taking suggestions on wheels..
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
Tailgate too
|
Re: What did you do to your truck today? Chapter II
Quote:
Those wheels that are on there now are killer. :metal: |
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
I installed a voltage gauge into my cluster to replace the ammeter
|
Re: What did you do to your truck today? Chapter II
Nice job on that truck JCblue
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
Quote:
|
Re: What did you do to your truck today? Chapter II
Thanks I couldn't figure out how to flip it lol
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
It's still a truck so I used all 400 hp to help a buddy move some stuff.
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
Quote:
|
Re: What did you do to your truck today? Chapter II
EKguy love the rims/caps.You can put some serious rubber on those! I took my truck to the salvage yard today to unload scrap. I did keep the load receipt 4,180 lbs empty ( gas tank on 1/4) with me in it. I'm a buck seventy ,so 2 tons of fun!!!
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
New dash pad and removed the Chevy horn button for the better GMC button :gmc2:
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
Used a small brush to touch up the engine this morning.
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
...
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
1 more
|
Re: What did you do to your truck today? Chapter II
1 Attachment(s)
Also finished installing new rotors, caliper, brakes and SS lines.
|
Re: What did you do to your truck today? Chapter II
9teen69, very clean looking !!!!
|
Re: What did you do to your truck today? Chapter II
5 Attachment(s)
got a little more under hood cleaning and painting done lot more to go what a mess
|
Re: What did you do to your truck today? Chapter II
Replaced both power steering hoses, due to a leak. Primer painted the rear end / bed of the truck.
|
Re: What did you do to your truck today? Chapter II
All I did today was primer coat my hood hinges and hood latch.
|
Re: What did you do to your truck today? Chapter II
5 Attachment(s)
fixed my broken choke cable.
nobody said it was a easy fix lol. i didnt know that the tube had a seem and the sheathing was crimped into the tube. so i split the end of the tube open and peeled some of the plastic coating off the sheathing. then i snipped the broken part off and recrimpped it back in. a very small tack weld will keep it in place for good. not shown is i also welded a small bit on the knob end filed and rethreaded it so the knob will not pull off anymore:metal: also got most of the (526)white sprayed the nason paint was really thin and transparent it took a few coats. also installed a heater box cover from a c/50 pretty cool ad on. i didnt realize the black cover was so hard too see till i uploaded the pic :lol: back to sand sand sand |
All times are GMT -4. The time now is 03:51 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com