66 C10 Dual Exhaust Routing Photos w/396 bbc
Need some input on how to run dual exhaust on this truck.
Going with 2.5 pipe with either Flowmaster or Magnaflow |
Re: 66 C10 Dual Exhaust Routing Photos w/396 bbc
2 Attachment(s)
Here is a 2.5" Exhaust route as an example. Not mine.
|
Re: 66 C10 Dual Exhaust Routing Photos w/396 bbc
looks dangerously close to bed wood and gas tank:exit:
|
Re: 66 C10 Dual Exhaust Routing Photos w/396 bbc
Quote:
http://67-72chevytrucks.com/vboard/s...d.php?t=779407 |
Re: 66 C10 Dual Exhaust Routing Photos w/396 bbc
Ya those cross members in the bed are how deep? I'm doing closely the same thing only with 2.25 pipes. Since I get under there with the installer . . The only place that will the closest will be over the rear axle still leaving almost an inch and with DEI Flexible Pipe Shield there I'm concerned - Not.
|
Re: 66 C10 Dual Exhaust Routing Photos w/396 bbc
Noticed pipe hangers and hardware
Any good sources? |
Re: 66 C10 Dual Exhaust Routing Photos w/396 bbc
This thread shows how mine is routed on the outside of the frame rails. I was addressing resonance but I uploaded some decent pics. Having a manual tranny with the old cast iron bell housing puts another crossmember smack dab in the way for an inside job.
http://67-72chevytrucks.com/vboard/s...d.php?t=792007 |
All times are GMT -4. The time now is 01:29 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com