New engine pics
 

Finally got my new engine installed. Thought I would share a few pictures.

It is a 350, 4-bolt 010 block bored .040, flat tops Blazer 284-2H cam. Quick Fuel 650 Pro vac carb, Edelbrock Performer Rpm intake, 150 Flex-alite fan, B&M trans cooler. Shows about 300 HP on Desktop Dyno. Pulls nice.

The 2nd last pic is of my Lokar shifter.Some one was looking for this a few months ago. Sorry for the delay.

Peter

Looks awsome! :cool:

Lookin' good.

very nice!

nice setup u got there :metal:

Nice setup. Looks good!!!

I've got the same tranny cooler. How did you run your braided lines? I used bulkheads and ran them right through the radiator support under the battery. What did you do???

nice job!, you may want to check heater hoses placement, i believe thier backwards of the way they should be hooked up.

hoses
 

Thanks for the comments.

Yeah I have to change the hoses around for the heater. I put the heater core in upside down I think.

I ran the braided hose through the turn signal mounting holes in the splash pan.

Peter

looks sweet

Im running the same trans cooler too. If Im not mistken the instructions say to mount it with the in and out to the side or to the bottom, not the top. I ran mine with hard line under the core support and along the inside of frame rale.

very nice!!