Track times
 

Is there a place to post track times? I am new to the board and thought I would ask. Mine is still underconstruction but here are my stats.

Motor:
383 with eagle h beam rods
560 lift roller cam
Victor intake w/ holley 800
175 hp nitrous
AFR 195 heads
MSD 6al ignition

Chassis:
Stock height for now till i can afford to lower
4.10 rear gears w/ modified th350

Interior:
Kicker comp 12's (2) and 4 pioneer 6x9's

Total weight with me in it was 4200 lbs. Best et was 12.50 @108 with the needle stuck open on secondaries.

Please post track times or show me where they are at

Welcome to the board. I tried to get a drag racing forum started here a few months ago, but it did not get too far. Nice combo and times. My time is in my sig.

nitro
 

Is that with the nos or without cause with the nos that seems kinda slow

that was with and like i said the needle was stuck so it looked like a diesel. That was also with 20 degrees of total timming when it should be more like 30. But with a 2.2 60' time due to spin it wasn't that bad of a run. What should i be running???????

I would think with any built motor and 175 shot of nitro i would guess 11's

i know a guy that has a 76 long bed with an olds 455 and 300 shot and runs 11.90's @110 with a 1.6 60'. Have you ever been to a track before? with the right tune i might hit 11's as is with the single track rearend.

Sounds like a good run to me for a 4200 lb truck. ;)
Good job and welcome!

Sounds right on the money to me. I'm running a 548cu/650hp through a T-400 with a 3.42 gear and 28X12's. I was spinning right through the 60ft. running 2.01 and 2.03's. I'm gonna put a sportsman 4-link and will probably pick up 1/2 sec or more. 12.50's are my best times but I have room to improve.

Either way that's still hauling @ss!!! Sounds like a fun truck. I am still trying to break into the 14's :(

im trying to brake into the 13s.

I'm just trying to get mine to run at all. :banghead:

bump

Was that time on the Nitrous kit? When I get a posi in my truck, I'm going to the track, in hopes of running somewhere in the 14's. Remember, 3800lb raceweight, good air, and a 225rwhp motor, might do it.

I'm just trying to get me AND my truck UNbroke. $$$ :-) , DAVE

Yes only made one pass on motor with 28 degrees of timming (should be 41 degrees) and went 13.6 @98mph. The 12.50's were at a concervative 18 degrees of timming. Next time out i am going to do some tunning since it is running right now and get the timming up where it should be.

I plan on adding this feature in the future, but the new version for the upgraded board software isnt out yet. Once it is released I will be installing it for us all to use.

Got any pics? I'm getting 195 AFR heads too. How do you like them? Did you order them with all the options? Rocker arms? Rollers? Studs or bolts?

Hey man I am glad you made it to the forum here. I guess I couldve told you about it on WR.com but I never thought about it.

Yeah thanks a lot for nothing :). I like the 190's a lot, dropped a sec off the bottle.