Parts for Sale
 

I have some things that need a new home- out with the six in with the eight.... Alternator bracket set I6 (250) $10, Heater control, face plate has been screwed on, but at least they are counter sunk... $5, 250 double groove upper pulley $10 and 250 harmonic balancer double groove $15. These prices are before shipping, and I am always willing to trade for parts. I need a set of 71-72 stock valve covers- 350, also need set of stock horns and good relay for them and a block off plate for automatic. I will have I6 motor mounts and manual trans crossmember for sale later in the month as well as the bell crank and associated hardware for the clutch linkage pedal springs throw out bearing arm etc. Thanks Harold


Newly added parts - pair of big block chrome valve covers, they are as stock but w/o drippers. They have the correct brackets for the trucks. they are from Danchuk parts have been installed and put back in the box 10 minutes run time only. Stayed with originals- $50 and shipping. Harold :bowtie:

Heater control, face plate has been screwed on, but at least they are counter sunk can i get a pic is it usable?

It is usable, sorry I Dont have a dig. camera all the levers are intact and the switch was good the last time the truck, ran 1st part of the summer this is simply not a show piece but if you need a decent control this will help you out.

shipping to 87506 or is that 5 shipped?

I think Donnie (bigorange) was looking for a balancer.

Riddla- $5 and Ship should not be more than 3.99 sound ok?

ttt

Harold
What is the carb like from your six? Is it up fro grabs?

Carb is ok it does not hold prime as it should after sitting for a long period of time 2 days- prob. needs a proper rebuild $15.00 and shipping. I also have intake and exhaust for this thing, will make someone a good deal. Harold

that sounds good m/o okay?

Riddla, address is Harold Shepard 2 Anne street, Canton NC 28716