Replacing inner/outter tie rods.
 

This is the first time I am replacing tie rod ends. I am doing this on my 1967 C10.
I know I must count the threads to the sleeve on both sides. But, is there anything else I should do, any short cuts or hints, sure be appreciated.

Thanks much!!

Check out everything else too. Just count out the threads and set it up the same way you took them off. After it's all done, run it to a shop and have them aline it.

------------------
71 basic C-10 350. The only option is the rust.No nothing on it, but thats all about to change. <A HREF="http://www.geocities.com/stevemau/slam33page.html?1004806705410

" TARGET=_blank>http://www.geocities.com/stevemau/slam33page.html?1004806705410

</A>