Where on the door frame would I drill a hole for the domelight switch?
 

My 67's have no domelight switches, & I'd like to wire up some but I'm not sure where to drill the hole in the door frame near the dash. Where would I drill the hole? Pics would be appreciated. I know some people drill the hole near the back of the cab, but I'm mainly looking for the factory position. Thank you for looking!

Re: Where on the door frame would I drill a hole for the domelight switch?
 

there is no factory position on the 67/68, the spot where the switch was placed on 69 and up is a raised position about 3/4 the way up. That mounting pad is missing all together on yours and the switch would not reach the door.

Re: Where on the door frame would I drill a hole for the domelight switch?
 

Someone has a thread a while back where they replaced one of the door bumpers at the rear of the door with a switch and then put the hollow top of the bumper over the switch so it looks like a bumper with switch in the middle, also on drivers side the wires are right there so might be an easy mod, I have not tried it myself.

Re: Where on the door frame would I drill a hole for the domelight switch?
 

I put mine in the top door bumpers. They fit perfect, and there is no drilling involved. The wires are right there Here's a link to the thread

http://67-72chevytrucks.com/vboard/s...d.php?t=151398

Re: Where on the door frame would I drill a hole for the domelight switch?
 

hmmm. i was kinda hoping to put the switches away from the back of the door but I may have to do it that way. Couldnt I put them at the front & shim them up with a few washers or something? thanks for the input so far guys.