sealing transmission hump
 

When putting a transmission hump on, should it be sealed or not? If so, what type of sealer should be used?

Thanks for the reply!!!!

the factory sealed them, used the fender welting used on the bed wheel tubs, etc


------------------
Randy- Lincoln, IL

r68c30@hotmail.com 2177353230
-71 C-10 350/CH465/3.07, assemble it, yeah right, that'll happen in this world,(not)
-84 Z28 Camaro 5.0L 700R4, 3.73, beater, paid way too much for it like an idiot,,
-84 Firebird SE 2.8L T-5, rod knocking, dammit,,
-82 Firebird 350 4bolt (TBL)/TH350, not running, dammit...
buy/sell/hoard/trade most any GM vehicle parts of any kind
-parting out: '81 Cutlass Supreme Brougham
*Paint is overrated
© RSS Enterprises 2000

I use RTV silicone to seal mine.

could also use thast gray foam sticky thick tape kinda stuff, tub caulk would work wel and cost way less and be just as good, works for rear axle covers too


[This message has been edited by Fast68Chevy (edited April 27, 2002).]