The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)
-   -   Windowcrank/doorhandle clips... (https://67-72chevytrucks.com/vboard/showthread.php?t=255903)

Sinister 08-28-2007 07:23 PM

Windowcrank/doorhandle clips...
 
I went ahead and bought the tool that says it removes and installs these clips/retainers.
It removed them pretty well, I just can't figure out how to get it to install the clips.
Any ideas/tips would be greatly appreciated...

C10-Driver 08-28-2007 07:26 PM

Re: Windowcrank/doorhandle clips...
 
I usually install the clip on the handle first then press the handle onto the crank until it "pops" into place. Not sure if that's how it's supposed to be done but it's real easy.

MXmaniac 08-28-2007 07:26 PM

Re: Windowcrank/doorhandle clips...
 
With the handles off the door, put the clips on them, with the open side facing down the handle, and then press it all over the shaft and it will clip into place.

Sinister 08-28-2007 07:33 PM

Re: Windowcrank/doorhandle clips...
 
Thanks for the quick replies, I'll go try that right now... :metal:

Sinister 08-28-2007 07:43 PM

Re: Windowcrank/doorhandle clips...
 
That was it. Thanks again... :c2:


All times are GMT -4. The time now is 05:31 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com