WTB 2 Groove Lower Pulley for PS - SWP, 283
 

I would like to buy a 2 groove lower pulley for my 283. I have a SWP, and I'm adding PS. The dia. needs to be 6 3/4". Here are the measurements as taken from a table top (like it would mount on the motor). The first groove needs to be ~1/2" on center and the second groove needs to be ~1 1/2" to 1 3/4" on center (as measured from the table). I think these are separate, stacking pulleys but I'm not sure. If they are, I have the main one (for water pump and alt.) but I need the PS pulley.

Can anyone help??

Please reply.

Re: WTB 2 Groove Lower Pulley for PS - SWP, 283
 

I think I have one.....let me check

Re: WTB 2 Groove Lower Pulley for PS - SWP, 283
 

Is this the one you're looking for? If so, $20.00 shipped to you.

Re: WTB 2 Groove Lower Pulley for PS - SWP, 283
 

I can't be sure. The first groove looks like it's correct but when I measured for the second groove I thought it was farther out than what yours is. I could have measured wrong. Can you tell me if there are any pulleys that have the second groove a tad further out?? I don't mind the $20 to find out but this is my second attempt and I sure would like it to be correct.

Than ks!!!

Re: WTB 2 Groove Lower Pulley for PS - SWP, 283
 

I don't think this one will work for you. Here is a picture of my setup. The back pulley is for the alternator & water pump & the front pulley is for the ps pulley and is spaced about 3/4" away from the rear pulley. This is a 2 piece pulley setup on the crank. If you have a double ps pump pulley, then this one I have may work.