The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1960 - 1966 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=6)

- - Floor pans (https://67-72chevytrucks.com/vboard/showthread.php?t=310467)

boxer1381

10-14-2008 12:30 PM

Floor pans

I also have just bought a driver side floor pan for my 62 from LMC it was way over sized so is it ment to just cut out the rusted hole in the old floor and just patch because on the new one there is about a 6"lip on the out side of the pan that i have no idea where it goes it is in the down ward angle about a 45 degree angle and hits the door sill and kick panel any sugestions?

Rogue 64

10-14-2008 12:38 PM

Re: Floor pans

Are you doing rockers?

boxer1381

10-14-2008 12:41 PM

Re: Floor pans

My rocker are ok just got about a 8" rust hole in the floorboard bout half way between the fire wall and seat location

All times are GMT -4. The time now is 05:51 AM.