Did some work on the truck.. Very little
 

I did a little work today. Not much but something. I can weld it up on Tuesday sometime. Also, saving old bed fronts make for good patch panel steel. :uhmk: Had to make sure my HEI would fit in there also.. :devil:

Re: Did some work on the truck.. Very little
 

Nice...

Re: Did some work on the truck.. Very little
 

looks like hei justa fits and attsa nice!:thumbs:

Re: Did some work on the truck.. Very little
 

dude, good call on the front panel for patches.....
why didn't i think of that?

Re: Did some work on the truck.. Very little
 

I have a similar distributor set up on my truck, 65 c10 with a 350. A friend of mine said it looked a little close to the firewall and might cause some problems. How much space is needed between the firewall and distributor to prevent any problems?

Re: Did some work on the truck.. Very little
 

They work good if they are not all beat up. This one was beat up on the drivers side but the passenger side was like a baby's bottom.. I have many more patches to cut out of. Nice gauge steel too.

Re: Did some work on the truck.. Very little
 

dude on my Nova if you can fit a credit card in between the hei and the wall I'll give you $20! LOL.

NO joke... its tight....

Re: Did some work on the truck.. Very little
 

Do you have a heater going back in it?

Re: Did some work on the truck.. Very little
 

Little is better than none...Did you ever get your brothers car out of your garage ??

I know you can use the space...;)

Re: Did some work on the truck.. Very little
 

I plan on some kind of vintage air or somthing.
My brothers car is still in the garage. I told him to get his butt over here and I would line things up for him and he could put on the nuts and bolts into the front sheetmetal so he can drive it this spring when the weather starts to get nice again. Whenever that is. Heck I want to drive my truck then also.

Re: Did some work on the truck.. Very little
 

I got the piece welded up and some bondo on it. It is wavy but then again the firewall is kinda bent there and I am not going to waste to much time on it. It looks ok.

:wop:

Re: Did some work on the truck.. Very little
 

:lol:
hounding yourself for pics........priceless ;)

Re: Did some work on the truck.. Very little
 

:haha:

Joe, you have affected everyone on this board!

:haha:

Re: Did some work on the truck.. Very little
 

I figure I would do it before someone else did.. :lol:

I ran downstairs and snapped a picture for you guys. Next picture I take I want to see some primer or something on there..

Re: Did some work on the truck.. Very little
 

I agree, most were VERY tight. I think as long as it has room to turn for timing adjustments all will be fine.

Re: Did some work on the truck.. Very little
 

looks good!

Re: Did some work on the truck.. Very little
 

That's gonna be an awesome setup. Gotta love a fat motor!!

Re: Did some work on the truck.. Very little
 

I think I will keep this one going..