sun visor bracket screws
 

Near as I can tell, the machine screws that should be used to mount the sun visors to the inside of the windshied frame are 5/16 18 X 3/4" long. That size taper head screw wont seat all the way in the countersunk hole in the bracket. A 1/4 20 will seat in the bracket, but it of course is the wrong size to seat in the winshield frame nut.
Wha am I missing here?

Re: sun visor bracket screws
 

1/4-28? Didn't put a tap on it, but could check...anti-sieze and studs worked for my hardtop mount

Re: sun visor bracket screws
 

I put a thread chaser in the holes to check the size... 5/16 18

Re: sun visor bracket screws
 

I'm new to the boards but I do know that some have different tappers on the countersink of the head have you tried a different angle on the countersink?

Re: sun visor bracket screws
 

[QUOTE=mudman316;3111009]I'm new to the boards but I do know that some have different tappers on the countersink of the head have you tried a different angle on the countersink?[/QUOTE No, the brackets are powdercoated and ready to reinstall. I didnt think machine screws would be an issue.

Re: sun visor bracket screws
 

A member on here a few years ago turned replacment screws out of stainless steel. I can't find the post and I don't remember the username, just that the member had their own website and was repairing some serious bedside accident damage on a nice red Blazer.

Re: sun visor bracket screws
 

Good news: I found the board member who made these and the post where they were for sale: http://67-72chevytrucks.com/vboard/s...ad.php?t=83233

Bad news: this member hasn't been active in over a year and their website doesn't work anymore