Any ideas for a stand for my Panel body?
 

I'm finally ready to lift the body off my Panel. I need some kind of stand to put it on for however long it takes. It needs to be strong enough, and on wheels so I can roll it around my shop. I have lots of various sizes lengths of angle iron, I just need some ideas of how to build it.

Re: Any ideas for a stand for my Panel body?
 

Hey Pritch,
Virginia has always looked so good that I'm hoping she is getting a little more TLC. My suggeston and what I have seen is a cut off pair of bricklayer scaffold , using a set of scaffolding casters. New cross bracing pices need to be fabed. I finally got a second panel. Nothing to brag on, but hopefully with a little continuing TLC. I'll get it on the road. Good to see you on the board again!

John

Re: Any ideas for a stand for my Panel body?
 

That's a good idea, John. A lot simpler than what I had in mind. Thanks.