New Guy
 

I have read enough postings to see there is tons of knwoledge here. Wish I had found this site sooner. My son and I have a 72 C10 350/350 turbo auto trans. column shift. I see alot of guys are going from manual to automatic and we would like to do just the oppossite. I have to admit banging some gears is fun.

We would like to install a 3 or 4 speed on the floor. Any advice on how difficult this will be? The truck has a small hump. Will this require alot of tunnel cutting? Hanging a clutch? New drive shaft? Are kits available? Hopefully someone has been through this before.
Thanks in advance

Re: New Guy
 

Welcome aboard from Northern California!

BTW, you might try posting the tranny question in the engine and tranny section... good luck!

Re: New Guy
 

Welcome from Knoxville Tn.....If you go with a 3 spd. or a standard 4 spd. no need to cut the floor...Now a big 4 spd. like the 3/4 tons used would require cutting the floor....You will also need to add the manual tranny cross member....

Re: New Guy
 

:welcome2: to the board from Mid-MO!!!

You'll find this place to become your second home. :D

Re: New Guy
 

Welcome to the board from Harford County Maryland!! :)

Re: New Guy
 

Welcome from NY!

Re: New Guy
 

:welcome2: frome the Palmetto state where it is sunny and hot as the :devil:


PT :chevy:

Re: New Guy
 

Welcome to the board from Texas

Re: New Guy
 

Welcome from FT Worth TX.

Re: New Guy
 

Welcome to the board from Bluemont, VA.

Re: New Guy
 

:welcome2: FROM KNOXVILLE TN!!!