The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)
-   -   is this a factory tilt?! (https://67-72chevytrucks.com/vboard/showthread.php?t=36358)

Blue_71 01-14-2003 10:27 PM

is this a factory tilt?!
 
i have a auto tilt column that doesnt have a key hole, and has the rounded plug in on the bottem

sam's 72 01-14-2003 10:30 PM

Show us a picture of it! Hard to say by what you described.
Sam

Blue_71 01-14-2003 10:31 PM

i figured it would be, but i didnt know what else to tell about it, lol. it does have a 73-80 wheel on it

Rod 01-15-2003 12:20 AM

If there is only just over an inch of lower shaft sticking out the bottom... it may be truck tilt.

Blue_71 01-15-2003 04:40 PM

so out of the tube, near where the shaft goes between the column and gear box?

Southpa 01-15-2003 04:57 PM

I got a tilt column out of a mid-70's Rally-six GMC van. Steering wheel is identical to my stock steering wheel (even down to the cracks :D ). But the wiring plug and neutral safety switch was different. Aside from that, would this tilt column be pretty much the same as the stock tilt columns for 67-72? Btw, the van tilt did NOT have a steering arm, I used my own.

Rod 01-15-2003 11:12 PM

Yes... Blue 71.

Hooter 01-15-2003 11:41 PM

What do the tilt and turn signal knobs look like?

Rod 01-17-2003 01:24 AM

1 Attachment(s)
Pic of bottom shaft length of Van Column


All times are GMT -4. The time now is 03:30 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com