Can anyone Id these cross shafts, pitman arms and ball joints?
 

i had these off a roller truck and they are brand new never used except for mock up.

Can anyone Id them? they do not seem like Moog as that is what I was told was on it.

anyone? are they worth reusing? I was going to purchase Moog lower ball joints and tie rod ends and want to see if these would be worth reusing.

Ill be using lowering spindles and springs so I want good quality components

http://i58.photobucket.com/albums/g2...3/IMG_0559.jpg

http://i58.photobucket.com/albums/g2...3/IMG_0560.jpg

http://i58.photobucket.com/albums/g2...3/IMG_0561.jpg

http://i58.photobucket.com/albums/g2...3/IMG_0562.jpg

Re: Can anyone Id these cross shafts, pitman arms and ball joints?
 

I just bought PartsMaster components for my front end. Made in USA, and when I compared them to the Moog, they were identical, and about 1/3 of the cost. Those components you have look brand new there...

Re: Can anyone Id these cross shafts, pitman arms and ball joints?
 

They were brand new just installed for mock up. I dont want to install something that someone knows is junk.
Ill probably buy moog lower ball joints and tie rod ends but these seem as though they should work just fine

Re: Can anyone Id these cross shafts, pitman arms and ball joints?
 

That is a small fortune in parts, no matter what brand. I'd be inclined to use them if I had them, and they really are "as new" as you say they are.

Re: Can anyone Id these cross shafts, pitman arms and ball joints?
 

yes it is a small fortune... lol

You can look and see that they were never pumped with any grease or have any wear marks lol

Re: Can anyone Id these cross shafts, pitman arms and ball joints?
 

I would use them without question. Even if you "only" get 75,000 miles out of them instead of 100,000, you are still way ahead of the game. I agree, they look brand new, outside of being painted.