Manual transmisssion hump pic's of t-case shifter boot and ring
 

Swapping out my Dana 20 case for my new NP205. Got a new boot and ring, but look totally different than my d20 setup. Any advice on this area? My original t-case shifter retaining ring is totally different than the round one for the 205. Got to get batteries for the camera and I'll show some pic's of what I'm talking about. Basically my original setup was rectangular with the shift pattern embedded into it. The np205 ring is round. Here is what's there now.

Re: Manual transmisssion hump pic's of t-case shifter boot and ring
 

Not 100% sure, but I think the hole will be moved over to the passenger side off center. and the hole is oval. I don't think is any different than an auto/205 hole in the hump, but don't quote me on that. You need a 205 shifter if you don't have one yet along with the boot and ring from a 205 as well. Your best bet would be to find someone with a 4spd/205 hump and just unbolt yours and sell it off. Trevor

Re: Manual transmisssion hump pic's of t-case shifter boot and ring
 

Got the shifter, boot and ring. Looks like I need the right hump now. Anybody got any pic's of their's? Manual 4 speed trans with 205 case?

Re: Manual transmisssion hump pic's of t-case shifter boot and ring
 

Heres a pic of mine freshly coated in bed liner.
http://i301.photobucket.com/albums/n...5/P1040701.jpg

Re: Manual transmisssion hump pic's of t-case shifter boot and ring
 

Sweet!