The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=4)
-   -   head of a vortec 350 (https://67-72chevytrucks.com/vboard/showthread.php?t=422209)

mike79foster 09-20-2010 12:32 PM

head of a vortec 350
 
a friend of mine told me for horsepower gain, i should swap my heads with some off a vortec 350. has anyone done this? what are the pros and cons?

thanks

camshaftgsxr 09-20-2010 01:19 PM

Re: head of a vortec 350
 
if they are the fast burn heads (they will have what looks like mountain peaks on the front surface) and you have a manifold that will match i say go for it they make some decent power especially with the right cam.

they can be had from http://www.jegs.com/p/GM-Performance...49896/10002/-1

the intake manifold is different but everything else will fit up (except the tbi unit(however a 454 tbi should fit fine))

STOCKISH 09-20-2010 01:25 PM

Re: head of a vortec 350
 
They also make carbed intakes for Vortec heads. The Vortec heads with the right cam, and Edelbrock air gap intake WILL put down 400 horsepower on a stock 350 bottom end. Considering your bottom end isnt worn out. I have personally had one with stock bottom, STOCK vortec heads and springs, Edelbrock intake, and cam(dont remember specs but you dont need alot of cam with these heads) 750 Holley carb that put down 377 @ the tires.;) Do a google search for Vortec head swap.

silvereagle07 09-20-2010 04:06 PM

Re: head of a vortec 350
 
The vortec heads make good power. The only cons I can think of is the limit on the cam lift and the intake is vortec head specific. I have a built a 355 with slightly modified vortec heads almost ready to go in my swb. It has a gm hot cam setup.

slamd83c10 09-20-2010 05:11 PM

Re: head of a vortec 350
 
i used a set of vortecs from a 97 model and bought a professional products carb intake form summit, and let me tell you, for the money i saved instead of going with aftermarket, it was well worth it..
i then rebuilt the bored .040 and stuck a comp 268xe cam in, and got the vortec heads cleaned and just had them do higher lift springs and that engine was a beast... alot of torque and very quick.... i say go for it....


All times are GMT -4. The time now is 11:53 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com