The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=4)
-   -   In your opinion....oil pan gasket or rear main seal (https://67-72chevytrucks.com/vboard/showthread.php?t=422980)

DetroitIron 09-25-2010 10:28 AM

In your opinion....oil pan gasket or rear main seal
 
Finally identified the area of my oil leak...pulled the trans flex plate and wiped oil pan and everything down....then watched the garage floor for couple days. I have small oil drip EITHER from the rear main OR the rear oil pan lip/gasket area(just below the rear main seal). Before going any further dropping the oil pan or even more fun sliding trans/transfer case back, I thought I would check with the experts on here for any visual tips in determining the source. btw I have check oil sending and rear intake gasket area. The pan and one piece gasket was replaced just recently...so I'm leaning towards rear main, but it's such a small leak (fifty cent piece size spot on garage floor after two days...i thought rear main seal would leak much more when they go) I don't know if the rear main seal is the culprit or whether oil pan gasket at the rear hump isn't sealing 100%....Any suggestions? Thanks Guys!!

moneyeater 09-25-2010 10:42 AM

Re: In your opinion....oil pan gasket or rear main seal
 
Hey detroitiron,
iŽm facing the same problem + leaking valvecovers + intakebolts!
IŽll just watch what the experts say! I think changing the rear main seal is no walk in the park, right? I have all the seals and gaskets laying in my shelf but to change all them it would be best to pull the motor out!
Volker

78 Chevyrado 09-25-2010 11:53 AM

Re: In your opinion....oil pan gasket or rear main seal
 
I'd buy one of those 1 piece oil pan gaskets and change that only. then if it still leaks from the main seal, you'll know about it and the new oil pan gasket it re-usable so then you can remove it to fix the main and not lose money on yet another pan gasket.

You can change a rear main in the truck. you just remove the pan and take off the rear main bearing (carefully so as not to upset the way the bearings are in there.

If the pan wont come off because it hits the crankshaft, youll have to rotate the crank by hand until you get it to a spot where the pan clears.

DetroitIron 09-26-2010 09:36 AM

Re: In your opinion....oil pan gasket or rear main seal
 
Thanks Guys! I needed to get my plow moved to the shop for a pre-season check....so I guess the oil leak fix will wait for now...plus I may pull the engine in the Spring to update a few things. Thanks Again!

moneyeater 09-26-2010 01:04 PM

Re: In your opinion....oil pan gasket or rear main seal
 
Talked to a specialist today and he told me that it is nearly impossible to get the two piece rear main seal dry because of its design! when an engine stands still a longer time the seal adheres to the crank and when the crank turns material is ripped of the seal and itŽll leak!
He also said that the onepiece Oilpangaskets are expensive but worth the price!
IŽll get my motor out the truck later the year and make him change all the seals and gaskets. Spending a little more on quality parts is the way here!
Volker

turner16 09-26-2010 09:11 PM

Re: In your opinion....oil pan gasket or rear main seal
 
I disagree, mine sat for 18 years and it was the oil pan. The 1 piece oil pan gasket is amazing, pricey but what a fit. Even got new bolts with it.


All times are GMT -4. The time now is 09:06 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com