The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   LSx Swaps (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=206)
-   -   painless wiring (https://67-72chevytrucks.com/vboard/showthread.php?t=435591)

bigguy 12-14-2010 11:23 AM

painless wiring
 
Has anyone used a Painless wiring harness for their LSx swap? If so can you please tell me how you wired the fuse block ignition. My truck stays on after the ignition is turned off and key removed. I had to install a toggle switch to cut the power to that wire. i thought it might have been the alt. backfeeding, but i removed the wires from it and still the same problem. Any ideas?

matthew20061 12-14-2010 05:07 PM

Re: painless wiring
 
Sounds like you have constant power going into one of your ignition wires in the harness. Maybe you hooked up the wires to your ignition wrong?

BR3W CITY 12-14-2010 05:53 PM

Re: painless wiring
 
It sounds like the power source you needed was a switched source, but it ended up on a hot lead. Doublecheck the ign wiring, throw a multi-meter on there and cycle the power. You should obviously see power cut when you key-off.


All times are GMT -4. The time now is 05:58 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com