Anybody use this bumper on a square?
 

I was thinking this bumper could look good on my 76 2wd Blazer. I think it would clean up the look while still maintaining a stock look. I'm just not sure where I'd put my license plate..

Re: Anybody use this bumper on a square?
 

I think the van bumpers are wider..might look odd....
Posted via Mobile Device

Re: Anybody use this bumper on a square?
 

Hmm. You're right, it does look like the bumper hangs out past the side of the body more so than a truck.

Re: Anybody use this bumper on a square?
 

Also if I'm not mistaken I read the bolt pattern width is different as well, I was looking at a front bumper off a van at the U-pull yard.

Re: Anybody use this bumper on a square?
 

ive seen them in the yard too and wondered if they would work.. i like the looks of them

Re: Anybody use this bumper on a square?
 

This one would look nice if it aint to long. Would have to fab up some brackets. Its from a ford econoline van. I like the "smoothie" style look.

Re: Anybody use this bumper on a square?
 

i tried and like mentioned above the van bolt pattern is different than the trucks.
bit of a bummer because my van bumpers are mint and my trucks bumpers are not nice.

Re: Anybody use this bumper on a square?
 

I put one on my 80 truck and fits nice,Alittle fabbing with some flat stock for brackets

Re: Anybody use this bumper on a square?
 

Got pics?

Re: Anybody use this bumper on a square?
 

x2^^^ and of your flat bar brackets.
thanks.

Re: Anybody use this bumper on a square?
 

Try it and see what you come up with. That's the magic of working with metal. everything is possable. so pull it and have a floor jack ready to balance it on and see how it looks. o yea get some body work blue tape or that green masking tape and cover the rear corners of the bed so you dont accidentally scratch it.

Re: Anybody use this bumper on a square?
 

The framerails on vans are a lot wider apart than on the trucks.