![]() |
FNG from Fl.
Guess i better post an introduction. I bought my blazer when i was stationed in Utah. I bought it in Idaho because it was one of the few that i saw that had the A/C system on it and not too much rust damage. Utah uses salt for the roads so you see a lot of older cars with cancer. Its a 72 CST. It had the original block, dana 44 front, and 12 bolt rear.
Since i bought it, i put a 4" lift, 35" BFG KM2's, rough country 5000 shocks, replaced the 350 with a 327 that i built years ago but had low miles on it. I still have the 350 but ditched the late model heads that the PO put on. I rebuilt the front suspension with moog knuckles and tie rod ends. |
Re: FNG from Fl.
Welcome, sounds like a good project. Post some pics.
|
Re: FNG from Fl.
3 Attachment(s)
Utah 2007.
|
Re: FNG from Fl.
You can see the homemade sunroof in the 2nd photo. Those were 31 in Big o Bigfoots.
|
Re: FNG from Fl.
Very cool k5 and welcome to the truck board!
|
Re: FNG from Fl.
3 Attachment(s)
The inner and outer rockers are rusted out. Original color is Ochre. Since then i have rattle canned it Krylon desert camo.
|
Re: FNG from Fl.
Looks pretty solid, what are your plans for the 350?
|
Re: FNG from Fl.
Hey Ole Beater :hi: from Ohio :c2: lookin rig :metal:
|
Re: FNG from Fl.
3 Attachment(s)
Check out the seat covers.
|
Re: FNG from Fl.
Welcome from the this side of the state. Nice project to play with. Give me a shout if you need anything. I'm about 75% done with my 72 Blazer project. David
|
| All times are GMT -4. The time now is 08:52 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com