need some tips on putn a camaro subframe on 57 chevy pickup
 

getn ready to put an 79z28 subframe under my 57 3100 need some tips maybe some measurements where i should cut the frame anything well help thanks

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

For all of the measurements I bought the DVD from No Limit engineering. They are a premium sponsor here too so can probably help you better if u buy the DVD and still have questions... Best money I have spent yet on my build.
You can also run the weary feature on subframe swap, theres like a dozen subframe threads

Good luck! The conversion is a rewarding one!
Posted via Mobile Device

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

Hey just stumbled across this build thread, check out page 1, he shows some good photos/measurements

http://67-72chevytrucks.com/vboard/s...d.php?t=220256
Posted via Mobile Device

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

Here is something directly for the No Limit folks, hopefully this will help.

http://67-72chevytrucks.com/vboard/s...d.php?t=440771


Tri5

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

I did a subfram swap on a 57 a couple of years ago and I almost went the same way as Nolimit, but for my taste, it sits way to low when done. http://www.jalopyjournal.com/forum/s...amaro+subframe
I did the swap by follwing this post on HAMB, and it was awesome when I was done!

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

Anybody seen these before?:lol:

These are a 57 with a camaro clip!!!

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

hmm Im a little confused by this... the way the HAMB link installed the subframe, actually makes the vehicle sit LOWER (if i'm not mistaken) than the No-limit install. the higher the subframe sits above the frame, the lower the truck will sit.
when I did the No-limit install my subframe was at the same level as the original frame, the method you mention, and also similarly shown by the post below yours, have the subframe sitting above the original frame, thus the wheels will be higher in the wheel well, dropping the truck front end.

looks nice! just that method sits too low for me

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

Maximus,

You are correct it does make the truck lower (installing the clip under the frame) than the no limit way (even with the frame rails) because it does not have the kick up like when you install the clip with the unibody supports under the frame. I don't like getting in debates so I did not say anything, but since you said it first I thought I'd chime in.lol

By the way there is no such thing as too low.lol

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

Just run TALLER TIRES!!!!!!

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

thanks everybody ill check it out thanks

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

I stand corrected on the height issue after taking a peek at both methods.

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

But for some reason my truck didn't seem to sit as low in the front as the no limit way. These trucks look good with a bit of a lowered stance, but IMO there is a point when it looks retarded.

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

Yeah, yeah and its people that feel the same about a truck that sits too high, so to each his own. When you say things like that it is insulting to a lot of people. If you don't like it simply don't do it. Beauty is in the eye of the beholder. Some guys like big women some like em small skinny legs and all.lol
But nobody is wrong about what they like.

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

I like a skinny legged woman that sits low!:lol::lol:

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

never get tired of looking at these. ;)
Posted via Mobile Device

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

lol.

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

Kabwe, my brother in-law has a disclaimer for the debaters.it goes something like this:
My opinion is just that.It is NOT open for debate.It is just my opinion!

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

Hence the reason I said IMO (In MY Opinion)
If you get offended that easy, perhaps you should be on the Discovery web site tonight voting for Paul Jr because it hurt your feelings that Jessie James cheated on Sandra.

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

I'm SURE Kabwe was not offended, he is just lookin out for others...
Anyways, back on topic...

Ashtray455, Which way are ya going with your front end conversion???

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

looks familure:lol:

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

It DID hurt my feelings. I gave him credit for being marginally smarter than that and it hurts when I'm wronge!:lol:

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

Nope I'm not offended at all. There are a lot of people here that work very hard on their rides and like them low and even slammed to the ground on airbags. Those same people have a lot of knowledge, and comb this forum to try and help people. You've just called their rides "retarded looking". If you don't see that as a insult then that tells me something about you and there is no need to go back and forth on this.

The gentelman (original poster) asked for the facts. The fact is installing the clip with the unibody supports under the frame will give you a lower stance (with stock components) than if you installed it even with the frame rails. Its up to the original poster to decide what he is going to do now that he is armed with the information.

You got that right. I'm a car nut and I like everything from stock to way out customs. I know how hard this stuff is to do on your own in your garage, people work very hard to build something they like and I think its very insulting to make a statement like "retarding looking" when a guy bust his a$$ to build his truck.

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

maxium havnt decided yet was lookn at one guys i like the way his had turned out where he slice a section out of thframe then sliced clip an welded it in , but still reserching it

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

I think you are talking about the "no limit way" they sale a instruction dvd for 36.00 if you need it. Heres a link for you http://www.nolimitparts.com/prodinfo.asp?number=D-101

Re: need some tips on putn a camaro subframe on 57 chevy pickup
 

thanks kabwe man like ur truck lookn good