The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   WIW (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=83)
-   -   N.O.S. GMC Fenderside Tailgate (https://67-72chevytrucks.com/vboard/showthread.php?t=497887)

special-K 12-10-2011 04:48 PM

N.O.S. GMC Fenderside Tailgate
 
3 Attachment(s)
I'm thinking about selling this and have seen prices all over the scale. I'd sell it if the price was right. I see as much as a few hundred asked for nice used Stepside gates. So,what's a realistic asking price for N.O.S? Not all scratched up,no surface rust,pretty darn clean,yet. I just wiped it off from being in the shed:

Classic Bowties 12-10-2011 05:11 PM

Re: N.O.S. GMC Fenderside Tailgate
 
Hi Tim, if I were selling it I would have to have $600. on the low end to think about parting with it. The gmc version is harder to find than the chevy in nos, at one time I had five of the nos chev nb gates and am down to two left now and have been holding tight @ $500. on them. Mel :chevy:

fine69 12-11-2011 06:55 AM

Re: N.O.S. GMC Fenderside Tailgate
 
I agree that the GMC is very difficult to find NOS.

Up until a few years ago you could still buy the Chevrolet through the dealer.

I think Classic Bowties is right on the mark on this one.

special-K 12-11-2011 08:58 AM

Re: N.O.S. GMC Fenderside Tailgate
 
Yeah,the last Chevy Stepside tailgate I bought at the dealer was $80. But,it's been a while. I could buy square body bedsides for under $275 less than 10 years ago. But now an '87 is right about 25 years old,so just as rare as 67-72 parts were in '97...15 years ago. Next is the 88-98 parts dropping off the radar. Time sure is a trickster.

Thanks for the replies you guys.

DREW67 12-13-2011 12:34 PM

Re: N.O.S. GMC Fenderside Tailgate
 
You can still buy these NOS for $250.00

special-K 12-14-2011 12:21 PM

Re: N.O.S. GMC Fenderside Tailgate
 
I'll have to check on that. Kinda hard to believe when reproduction tailgates cost more than that. I'd appreciate if you could point me in the right direction.

DREW67 12-14-2011 04:20 PM

Re: N.O.S. GMC Fenderside Tailgate
 
Quote:

Originally Posted by special-K (Post 5064487)
I'll have to check on that. Kinda hard to believe when reproduction tailgates cost more than that. I'd appreciate if you could point me in the right direction.

http://www.classicparts.com/

The last time I bought a stepside gate classic parts of america had GMC for 249.99 OEM and I think chevy was the same but I think they have gone up now.

Thanks,
Andrew

VA72C10 12-14-2011 04:34 PM

Re: N.O.S. GMC Fenderside Tailgate
 
went on the site and they do have the chevy nos ones for 350, but no NOS GM ones...the reproduction GM ones are 250....

VA72C10 12-14-2011 04:35 PM

Re: N.O.S. GMC Fenderside Tailgate
 
If it were mine I'd put it on the board for 750 because of its' rarity...and since you don't HAVE to sell....

DREW67 12-14-2011 05:11 PM

Re: N.O.S. GMC Fenderside Tailgate
 
Quote:

Originally Posted by VA72C10 (Post 5064777)
If it were mine I'd put it on the board for 750 because of its' rarity...and since you don't HAVE to sell....

If you were to go buy the GMC you will find that it is NOS.

VA72C10 12-14-2011 09:18 PM

Re: N.O.S. GMC Fenderside Tailgate
 
Quote:

Originally Posted by DREW67 (Post 5064827)
If you were to go buy the GMC you will find that it is NOS.

That would be great but why does it say as original not original or NOS

Quote:

Detailed Description

Stamped steel with correct bends, welds & lettering as original

DREW67 12-14-2011 11:28 PM

Re: N.O.S. GMC Fenderside Tailgate
 
Quote:

Originally Posted by VA72C10 (Post 5065207)
That would be great but why does it say as original not original or NOS

It's been three years sense I bought and all I can tell you mine was NOS for $250 I guess they may have ran out.

special-K 12-15-2011 11:44 AM

Re: N.O.S. GMC Fenderside Tailgate
 
I followed your link and it's obvious all they have are reproduction GMC tailgates for $249.00. They do have Chevy N.O.S. for $349.00 which is cheap and under priced from what I've seen. A good rule of thumb is any N.O.S. part is worth at least double it's imitation. Things change as time goes by. I bought a N.O.S. Fleetside tailgate and hatch for my '72 Blazer for around $220 "a while ago" for both. Just a few years ago I got a '90 Blazer bedside for under $300. Once they are gone from surplus they go up. GM even raises the prices on old stock as time goes by. These tailgates have not been used on trucks for 25 years now. They are only required to keep parts available for 10 years by law. That's a 2002 now.Time keeps playing it's tricks. The 88-98 parts will be getting scarce. Looking for parts for my '92 is the same as looking for '72 parts was when my '92 was new. It was tough to find them back then.

Classic Bowties 12-15-2011 03:50 PM

Re: N.O.S. GMC Fenderside Tailgate
 
Quote:

Originally Posted by DREW67 (Post 5065496)
I guess they may have ran out.

:thud:, you had me hopes up for a minute there. Just confirmed with Adam @ CPOA, the gmc nb gates they offer are repro mar-k pieces. Mel :chevy:

Another thing to consider on the available leftover/surplus chevy OEM nb gates is that some of them are just that, oem factory seconds and not really NOS with nice crisp/sharp stampings.

mbgmike 12-15-2011 03:53 PM

Re: N.O.S. GMC Fenderside Tailgate
 
actually a MAR-K tailgate is nicer than any nos oem tailgate. much better made. The only thing is if someones wants to brag its 100% oem thats the only advantage.. $260.00 each retail. so anything above that would be a waste as theirs are top flite. same as what we used to sell

Tim Christian 12-15-2011 04:13 PM

Re: N.O.S. GMC Fenderside Tailgate
 
I bought one from Ed @ Mother Truckers about 10 years ago. He had 10 of the NOS GMC's @ $175.00 each.

special-K 12-17-2011 01:03 AM

Re: N.O.S. GMC Fenderside Tailgate
 
OEM is OEM,just like the truck. That's what it's all about to me. I don't brag or care what anyone else thinks. I build my stuff for me :cool:

It's good to know there are good reproduction parts.

Classic Bowties 12-17-2011 04:33 AM

Re: N.O.S. GMC Fenderside Tailgate
 
Quote:

Originally Posted by special-K (Post 5068917)
OEM is OEM,just like the truck. That's what it's all about to me. I don't brag or care what anyone else thinks. I build my stuff for me :cool:
It's good to know there are good reproduction parts.

I'll take mine in GM :bling: too, You are always a true gent as you put it nicer than I could have. Mar-K puts out some nice products, but its still and always will be readily available repro that can come with small issues/manf. flaws like heavy/overkill spotwelds on the nb gates. Mel :chevy:

special-K 12-17-2011 10:29 AM

Re: N.O.S. GMC Fenderside Tailgate
 
Yeah,to me the ultimate is an unrestored original and second best is restored with OEM parts,which is as close as you can get. OEM can be N.O.S. or excellent used as far as I'm concerned. It's only N.O.S. until you use it anyway. The '67 I'm building (at least I think I still am) is being built from all excellent used GM sheetmetal. Even the louvered hood. I want to do something with the tailgate to add a custom tough to the rear,so I'll probably use a blank reproduction tailgate.What I plan is my little secret. But,maybe I'll just paint the OEM one,too,when the time comes to keep that OEM thing complete. I'm considering also painting a stock hood so I can swap that on.


All times are GMT -4. The time now is 11:09 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com