![]() |
Speedometer troubleshooting help
This is for a 72 4wd Blazer, 4 speed, and np 205 transfer case.
The PO told me the speedometer cable was bad. So I picked up a new one and replaced it today without doing any trouble shooting to make sure it actually was the cable. Well, got it replaced and it still doesn't work. If I'm going fast enough, the speedo will bounce around a little bit. It never actually holds any speed, but it does move. I took the speedo cable off the transfer case and spun the cable. The speedo did move. So I figure it is something down on the speedo gear at the transfer case. After some searching I found this thread: http://67-72chevytrucks.com/vboard/s....php?p=2998056 This doesn't really look the gears on these things are going to wear out/break like the newer plastic ones. What should I be looking for? Maybe the gear is rounded out where the cable goes into it? Can you buy new speedo gears for these? Thanks Sean |
Re: Speedometer troubleshooting help
Maybe the gear or possibly a broken clip on the inside of the case that holds the gear in place against the speedo gear
http://67-72chevytrucks.com/vboard/a...1&d=1327876668 |
Re: Speedometer troubleshooting help
1 Attachment(s)
Is that diagram from an early 205 that doesn't have the plastic gears?
The attached image is from the linked thread. Doesn't look like the two images would go together. |
Re: Speedometer troubleshooting help
Quote:
|
Re: Speedometer troubleshooting help
Anybody else?
|
| All times are GMT -4. The time now is 06:52 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com