tach dash restoration leftovers ;)
 

I have around 12 printed circuits and several lenses but all have issues. Most printed circuits that were very bad I trashed. These have one minor spot most right near the connector. I feel they could be soldered and I might do that. But any value as is?

Lenses either have scratches or cracks. Most are tach but have a few tach with air. One tach with air the lettering is good except the air. Figure it will be good for someone adding a clock. Any thoughts as to value? I will try to post pics but its hard to show scratches.

Thanks.
Posted via Mobile Device

Re: tach dash restoration leftovers ;)
 

anyone sold any of this? If not, I'll solder one up to see if it works and use the lenses for clock conversions...

Re: tach dash restoration leftovers ;)
 

anyone? Going to break out the solder gun soon ;)

Re: tach dash restoration leftovers ;)
 

I guess I'll load some pics to see if that helps...a lot of views with no comments....

Re: tach dash restoration leftovers ;)
 

ttt

Re: tach dash restoration leftovers ;)
 

really? no thoughts as to value with over 130 views???

what about stock 7 gauge cluster tins, uncracked used bezels, good lenses, and printed circuits? Have a ton of those too....

Re: tach dash restoration leftovers ;)
 

Let's see some pics
Posted via Mobile Device