WTB Front Driveshaft for 72 K20 ....
 

Looking for a good front driveshaft that would be 28.5" long with the slip-joint in the middle of it's travel. This would be the center of U-joint cap to center of farthest U-joint cap. Probably would be 27" fully compressed and 30" fully extended.

Needs to fit a NP205 transfer case with a yoke and the double cardan joint at that end, and a Dana 44 yoke other end.

I have one that's been totally rebuilt that's 28.5" fully compressed, and 31.5" fully extended. Just put a lot of money into it, all parts replaced and balanced, like new condition, will trade for value.

Thanks.

72longbed

Re: WTB Front Driveshaft for 72 K20 ....
 

I got one that's short I will check the length. I m getting out of the 4 wheel drive stuff.

Re: WTB Front Driveshaft for 72 K20 ....
 

Sounds good ... pics too if you would please.

Thanks.
72

Re: WTB Front Driveshaft for 72 K20 ....
 

Sure will. Prob be tomorrow sometime. May can run outside shortly will get pic asap.thanks.

Re: WTB Front Driveshaft for 72 K20 ....
 

Will upload pics but mine is 25 collapsed. And around 27.5 mid way.will upload pics in a few.