WTB Bed Patch Panel Dallas
 

Don't send that bed to the scrap yard yet! In need of a bed patch about 8" x 48", long ways across the bed. I bought one from LMC and it was an absolute joke. Not even close to matching the existing.

I can pick up if you are around Dallas.

Re: WTB Bed Patch Panel Dallas
 

I have a swb bed ready for the scrap yard. It may have what you need. the pass front 1/4 panel has been cut out and sold. thanks

Re: WTB Bed Patch Panel Dallas
 

I should have mentioned it's the floor I am looking for. Do you have floor left or was it wood?
Posted via Mobile Device

Re: WTB Bed Patch Panel Dallas
 

Show me a pic I just cut up a floor cross ways may have a piece that will work for ya

Re: WTB Bed Patch Panel Dallas
 

I am out of town but its about 8" tall right between the wheel wells. I could use two at 8" x 24" anywhere from your bed. I will send a pic tomorrow.
Posted via Mobile Device

Re: WTB Bed Patch Panel Dallas
 

Yeah send a pic to confirm I understand, but I think I do and will make sure I didnt cut too narrow

Re: WTB Bed Patch Panel Dallas
 

This is what I need to patch. It's actually a little over five inches tall so a 6" tall piece would give me enough to trim and fit.

Re: WTB Bed Patch Panel Dallas
 

I worked 7:00am to 12:00am yesterday so I didnt have a chance to look but I believe I have it. Just need to make sure it's not all dented. I'll let you know tomorrow.

Re: WTB Bed Patch Panel Dallas
 

Any luck Ol Blue?
Posted via Mobile Device

Re: WTB Bed Patch Panel Dallas
 

Thought I PMed you, I guess it didnt go thru from my phone. I have it. The longest box I can find at work is 21". So tell me the basic dimensions and how many and whether you want the cuts on the high or the low in the coregation of the floor. whew!

Re: WTB Bed Patch Panel Dallas
 

Sorry, you did pm me. Wierd I didn't see it. I need a total of 45 inches. Three pieces making that up would be awesome. Let me know what I owe you.
Posted via Mobile Device

Re: WTB Bed Patch Panel Dallas
 

No problem, would you prefer the cuts on the tops or the valley of the bed? Also send me the shipping address and I will let you know the total shipped cost after I weigh it I figure $20.00 plus the shipping. Fair enough?

Re: WTB Bed Patch Panel Dallas
 

PM sent

Re: WTB Bed Patch Panel Dallas
 

Jon, sent a pm so i'm trying to contact you before you send money so go to pm.
Posted via Mobile Device

Re: WTB Bed Patch Panel Dallas
 

Hey Old Blue,

Do you have any of the bed floor left?

I need the very end piece near the tail gate. About 12 inches from the end on both sides. Actually if you have a 12 inch square piece from the left andf right sides, that would be good.

Let me know. I will buy them if they are solid. I wont be back to Mich until next Saturday but if you can hold them, I will PM you when I get back.

Thank you.

Re: WTB Bed Patch Panel Dallas
 

Ol Blue just advised his bed was full of bondo so I am still looking. Probably headed to salvage yard this weekend. Are 73 and up the same in terms of flutes in the bed to 67-72 beds?
Posted via Mobile Device