mold for my glovebox pix
 

Last night I Made the mold to make a fiberglass glovebox out of my old one. Tonight I will start applying fiberglass. I shortened the box and recessed my computer on the bottom to keep it out of sight. It should come out nice.

Re: mold for my glovebox pix
 

-
Keep us posted on the progress. I've been trying to figure out where to put my ECM.

LockDoc

Re: mold for my glovebox pix
 

will do

Re: mold for my glovebox pix
 

In for this as well. I've been thinking about doing one with a spot for my radio.

Re: mold for my glovebox pix
 

Let us know how this works out.

Re: mold for my glovebox pix
 

Not as sharp but it has been sitting in the glove box now for over 20 years like this. I never finished installing it. I may have to finish it up after reading this and seeing the pictures.
The red light and switch are wired up to jumper the ADL connector to read the engine codes by the light flashing.;):chevy: :lol::lol::lol:

Re: mold for my glovebox pix
 

Bought a replacement from brothers to replace original then had heater/ ac issues. Had to pull out again and was not that easy going out and back in. Seems to me there needs to be some flex in there to get all the holes lined up but I could be wrong. So long as you have the room and nothing in the way I guess. Just a caution or thought. Good luck and let us know how it goes.