ceramic coated headers
 

Does anybody have any recommendations for a place near Burbank CA that will ceramic coat my headers?

Re: ceramic coated headers
 

Try calling Ultramet in Pacoima

Re: ceramic coated headers
 

You can DIY if you have a big enough 500F oven.
Ceramic coating is very strong.
Great for coating headers and other small parts.
Can polish to high sheen w/ elbow grease.
I just polish in media blaster because it is very quick and easy; leaves a satin finish.

Who ever coats them, make sure they are properly prepped because it is a very difficult coating to remove and redo.

Re: ceramic coated headers
 

So is what you are doing in the oven, ceramic or powder coating? Is it applied the same way and then baked on?

Re: ceramic coated headers
 

It is ceramic coating.
Cost about $20 per bottle.
One bottle will coat two headers and several small parts.
Applied w/ paint gun; used small tip size because it is thin.
Sprays out nice.
Coating is very weak until cooked.

I don't have powder coating system but hope to one day.

Re: ceramic coated headers
 

There is Cap's up in Fresno. I had a couple of stock manifolds ceramic coated in a Cermachrome finish and it ran me about $180 for both.

You can find them at www.capscoatings.com