The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=4)
-   -   turn over but will not start (https://67-72chevytrucks.com/vboard/showthread.php?t=581868)

wittyandnitty 05-26-2013 07:43 PM

turn over but will not start
 
I have an 81 c10 with a 350 and it will turn over, plus it has fuel going in, but I won't start.
Posted via Mobile Device
Posted via Mobile Device

Sabaka454 05-26-2013 08:09 PM

Re: turn over but will not start
 
Did you check for spark? check the ignition system

wethepeople406 05-26-2013 08:17 PM

Re: turn over but will not start
 
F.A.S.T.
Fuel
Air
Spark
Timing
start with the basics good luck

wittyandnitty 05-27-2013 12:48 AM

Re: turn over but will not start
 
I think I made a mistake in the wiring of the starter. Are there any cables that go from the starter to the distributor
Posted via Mobile Device

Desert1957 05-27-2013 10:59 AM

Re: turn over but will not start
 
Quote:

Originally Posted by wittyandnitty (Post 6092131)
I think I made a mistake in the wiring of the starter. Are there any cables that go from the starter to the distributor
Posted via Mobile Device

Yes, there is a "Battery Feed" its the other little terminal on the starter solenoid.

Desert

Desert1957 05-27-2013 11:07 AM

Re: turn over but will not start
 
1 Attachment(s)
here is a pic
Attachment 1112354

wittyandnitty 05-27-2013 11:51 AM

Re: turn over but will not start
 
Thank you very much. I kept reading that there is no wire going from the starter to distributor if its HEI? Is this true?
Posted via Mobile Device

Shyguy 05-27-2013 01:16 PM

Re: turn over but will not start
 
If it has a Hei distributor it gets its power from the ignition switch, if I remember right. On some trucks there is a 12 volt feed from the large positive post on the battery to the fuse block, but I am not sure which years.

motornut 05-28-2013 11:24 AM

Re: turn over but will not start
 
the HEI wire comes out of the harness,through the firewall plug
not right from the bat(needs on/off)


All times are GMT -4. The time now is 04:28 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com