Rusty c10
 

So I'm finally starting to get my ducks in a row to refreshing my grandfathers c10 but so far I'm seeing rust...anyone recommend a sheet metal distributor?
Posted via Mobile Device

Re: Rusty c10
 

First off, welcome to the board from Arkansas! I went through the same deal with my grandfather's C10. I've used sheetmetal from a few different vendors.

For bed parts (header panel, roll pan, tailgate cross sills, bolt kit) I used Mar-K.

My cab corners, inner/outer rockers, inner foot well patches, lower door hinge pockets, and door bottoms came from Classic Parts.

Front inner fenders and rear wheel housings came from SOKY Classics.

I hear GMC Paul's has good sheetmetal too, but I haven't gotten any from him, I did however, buy a set of rear springs and a transmission crossmember from him.

All have been easy to deal with and the quality is good on everything listed above. No complaints so far.

Re: Rusty c10
 

Awesome!! and thanks guys Im looking forward to this project, I think Im going to yank the motor and get all that taken care of just a refreshing of it. and work on the body, I cant make it show quality but maybe a prerunner type setup...was always a workhorse anyway

Re: Rusty c10
 

What about LMC Truck? Are their repair panels any good?

Re: Rusty c10
 

Hey leviathon

:welcome2: to the forums and :hi: from Ohio.

Glad to see you are fixing up your Grandfathers :chevy:

Re: Rusty c10
 

Welcome!