6.2 diesel feed line
 

ok so the main feen line on my motor is shot i think. is there any ez way to replace it with out pulling the intake?? thanks, mike

Re: 6.2 diesel feed line
 

The hose or the pipe? The hose you can get to, the pipe's possible but a lot easier with the intake off. IIRC I had to buy a cheap line wrench and bend it, still had to take off the cruise and cable brackets. Intake removal's not too bad, just be sure the bolts go back in the same place because they are lenght sensitive. Good time to swap to a J code if you don't have one. Also a manual glow system, I took out the EFE/EGR solenoid pack and used that stud to mount the ferd relay for the glows.

Re: 6.2 diesel feed line
 

yea mine is a j code and the glow is on a toggle already. i am just going to pull the intake and fix it right on one shot

Re: 6.2 diesel feed line
 

Do you need the steel line and rubber hose from the fuel pump up the block or the one on the front of the block for fuel return...I have both available would just need to find a proper box to prevent bending.

Re: 6.2 diesel feed line
 

48cj2a do you have a pic of the one that goes to the fuel filter?? i want to say mine has been cut. thanks

Re: 6.2 diesel feed line
 

Here you go, has all the clamps and lines intact $25 + shipping

http://48cj2a.com/images/cucv/6.2/6%...uel%20line.JPG

Re: 6.2 diesel feed line
 

thanks. but i will have to pass. just found out i am being throughn out of my house in 4 days. fml so looks like rubber house it is

Re: 6.2 diesel feed line
 

Sorry to hear that...let me know if something changes and good luck!