![]() |
Tire question?? And ratio?
Hi, I'm new to this forum. I have a 1987 silverado v10 with a 350 tbi. It has a 700r4 tranny and np08 transfer case. I just recently put 3:73 gears in. I want to put 35s on and wonder if it will have good power for wheelin and towing. So is this a good setup? And I also want somewhat good gas mileage.
Posted via Mobile Device |
Re: Tire question?? And ratio?
That is a gair high because of the od and 35's. but will help with gas. The 700 is a good tranny just weak so be careful. The 208 is stout just watch for chain wear. You git a good setup could always change axle's to somethin lower, but you'll give up gas. Drive it, see how it stacks up. I think you will do about as good as ya can just keep the foot outta it lol.
Posted via Mobile Device |
Re: Tire question?? And ratio?
My 82 K25 has same gearing as yours,it's on 35s with the 833OD tranny behind a 6.2. This combo works pretty well so far,if I get into mud or snow just throw it into low range.You should be ok with the 350,it will probably have more jam than my 6.2..
Posted via Mobile Device |
Re: Tire question?? And ratio?
Thanks
Posted via Mobile Device |
Re: Tire question?? And ratio?
I would say it's a hair tall for towing, depending on your load, but not much. If I was designing from scratch I would have chosen 4.10, so your 3.73 really isn't too far off. I certainly wouldn't suggest going through the hassle of changing your gearing unless you're towing a rather heavy load on a regular basis.
|
| All times are GMT -4. The time now is 07:54 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com