66c10 350 and a m22
 

I have a 4 speed m22. And the linkage is hitting the header coming off the z bar it has long tubes not sure the brand of headers The z bar hooks up fine but the linage that comes off the bottom of the z bar hits the header going to the the clutch fork any pics or info would help thanks

Re: 66c10 350 and a m22
 

Is it the end of the rod that goes from the arm on the bellcrank to the fork that is hitting the header tube? If so just trim it off.

A pic or two of what you have would help.

Re: 66c10 350 and a m22
 

I had an issue also. I dont remember exactly where I was hitting but I had to cut off and reweld one of the arms on the Z bar. I think I had to bend on the arm also. It has been a few years and did not take pics, sorry.