Wanted: Dims for Aux Battery Windshield Washer Bracket (Right-Side)
 

I'm looking for dimensions "A" and "B" for a passenger side windshield washer bottle bracket, please.

A=distance bracket moves out from fender
B=lower hole to bottom of washer bracket

(Pictures borrowed from DeadheadNM)

Re: Wanted: Dims for Aux Battery Windshield Washer Bracket (Right-Side)
 

Just measured the one on my CustomCamper/30.

This is what I came up with:

A - 1-1/8"

B - 9/16"

Re: Wanted: Dims for Aux Battery Windshield Washer Bracket (Right-Side)
 

Thank you!

Is 1-1/8" to the top hole (not the bottom)?

Re: Wanted: Dims for Aux Battery Windshield Washer Bracket (Right-Side)
 

No, 1-1/8" was for dimension "A"

9/16" is actually from the top hole and I see "B" should be from the bottom hole so I've been caught not following directions so that was one big screw up.

It was a bit difficult to accurately measure in the truck (in the dark with a flashlight didn't help either). I figured removing two medium sized screws this morning might help overcome my one big screw up last night. So I pulled out the bracket and I'm revising dimension A and this time correctly measuring dimension B from the bottom hole per the instructions on the diagram.

So the good stuff has been triple checked and is:

Dimension A - 1-1/32"

Dimension B - 2-3/16"

Hope this helps. :mm:

Re: Wanted: Dims for Aux Battery Windshield Washer Bracket (Right-Side)
 

This is exactly what I need; thank you!

I'm going to make the Z-shaped bracket for my truck (probably going to use 1/8" steel plate) and I wanted to make sure it would fit.

Re: Wanted: Dims for Aux Battery Windshield Washer Bracket (Right-Side)
 

Here it is:

Re: Wanted: Dims for Aux Battery Windshield Washer Bracket (Right-Side)
 

Wow! Nice work.

Re: Wanted: Dims for Aux Battery Windshield Washer Bracket (Right-Side)
 

Looks good, great job.

How does it fit for ya? Looks like it'll get 'er done.

Re: Wanted: Dims for Aux Battery Windshield Washer Bracket (Right-Side)
 

It fits fine! I wouldn't have gotten it to clear the hood without your dimensions. Thanks!

I was able to extend the 5.06" location dimension from the power block to about 5.5" to give more side terminal battery clearance and still clear the hood hinge.